JES9750AAS Jenn-Air Range - Instructions

throw the old one in the garbage, drop in the new one. It is about 3/4" narrower than the one that came with the stove but still covers the down vent adequately

Used a multimeter to determine that power was going to the surface burner infinite switch. Then determined that power was not going from the output side of the switch to the burner element. Turned power to range off at the breaker box. Removed eight screws total on range top, four on the cartridge side, two located on back of control plate where the downdraft vent is located and two on the double fixed burner side. Raised the range top to gain access to the infinite switch assemblies. Removed to torx head screws retaining the infinite switch and then disconnected the five wires on the bottom one at a time, making sure to replace in the exact location on the new switch. Installed torx screws in the new switch and installed all screws back into range top. Reinstalled cartridge and burners and turned power back on. Tested rear burner and all functioned properly.

Disconnected power pulled oven from wall, removed 8 screws from back, unplugged sensor, removed old, attached new, put screws back wow saved me $500. From buying new and $150. For service call

Instructions did not included need to pull oven from wall to access connections. A pro knew what to do, was finished in 10 min!

Pulled out broken element, took out screws, put in the new part and inserted it.. My son had to do it though. Easy for him

Super easy; pulled out broken element and pushed in new element. Wonerful service, communication, shipping. Received part in Seattle and mailed it to Hawaii installed without a hitch. Thank you

Followed provided video

Just followed the instructions in the video!! A repair service was going to charge $95.99 just to walk in the door!!I I just ordered the igniter part. Watched the video and I know I can do that too!! I have only had one self igniting burner for years - didn't want to pay for a service call. Love your company!! Thank you!

First I took the door off and outside to dump the glass in the trash which I had some Kevlar gloves so not to get cut. Removed the three screws on the bottom trim piece and the two on the sides remove the outside face glass next remove the four screws that hold the next glass. This glass is in a frame there is bent tab on one corner unbend open frame and install inner glass close frame rebend tab and reinstall all the parts.