Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Hotpoint Refrigerator HSM25GFRFSA - Side-by-side R Series. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
The defrost heater keeps the cooling coils from frosting over. The heater will get hot and melt any ice or frost build up around the coils.
This assembly includes the auger, bucket, cutting assembly (blades) and cover.
This paddle, when your glass is pushed against it, activates the dispenser to release the ice through the funnel.
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circ...
This compression ring is meant to hold the evaporator fan motor in place in the freezer compartment of your refrigerator. This is is a genuine OEM part. The tools needed to complete this repair are a Phillips screw driver and small flat blade screw driver. Be sure to turn off your refrigerator before removing the evaporator fan cover so the fan does not turn on during repair. It is recommended to check the grommets, evaporator fan, and fan blades during repair in case they also need replacning. The compression ring may need replacing if the fan is noisy, or the refrigerator compartments are too warm. This part is sold individually.
This part is white in color.
This part helps to contain parts for the ice and water dispenser. The overlay and dispenser board is attached on the front of the housing shield.
The function of the run capacitor is to help the compressor turn on and off while maintaining a constant temperature in your freezer. If you notice that your refrigerator or freezer is too warm, you may have to replace the run capacitor. This part is 1-1/2 inches in length and is made of black plastic with two metal prongs which connect to a wiring harness. The run capacitor is in the back of the refrigerator and is mounted to the condenser fan motor bracket with a 1/4-inch screw. You will need to remove the lower back panel of your refrigerator to access this part.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.