GT2688PKCW Maytag Refrigerator - Instructions

inserted a knife between the switch and the plastic interior in order to pop the switch out.
then took off the 2 wires on the old switch put them on the new switch and reinserted the switch into the plastic interior.

I simply removed the old switch by gently pulling down on the old switch with a screwdriver. When it was about half way out I just gently pulled down on the old switch and it popped out... I removed the two connectors attached to the old switch by pulling on the connectors with a pliers...I tried using my fingers but wasn't able to pull the connectors off so I used pliers. It worked perfectly.. When pulling off the old connectors, make sure you attach the new switch to the same tabs on the new switch... It was very easy to do and took under 5 mins.....The light switch works perfect....P.S. You should unplug the frig while making the connection just in case....Safety first....!!!

Once I identified the bit that would remove the screw, the rest of the repair took 5 minutes. I removed the screw and discarded the remains of the original but now broken shelf support. With the same screw I simply attached the new shelf support that I received from PartSelect.com. End of story.

No repair needed. I had only to wash the new ones and use them.

I slid the meat tray out of the broken rails and after cleaning it I used a flat head screw driver to pry gently the plastic rails slightly away from the metal tray to unlock the broken plastic rails and slid them forward to free them off the metal tray.Replacement was very easy sliding the new plastic rails back on the metal tray until they locked into place then screwed the plastic wheels on to the new rails and replaced the repaired tray back into place. Thank you Part Select for your service and help.

Terry R. from Oklahoma City

I removed the switch housing (4 screws), replacing the switch in the housing was a snap. It took 5 minutes, cost $8 and light works like new!

Why didn't I order this part and do the repair earlier? Very simple.

Very simple fix, remove 3 screws, two connectors to the old switch

The light rocker switch wasnt working. I found the part on the web site. It was so easy. I used a screw driver to pop out the old one and pop the new one in. It took 5 min. Thanks!!!

I took a chance and ordered a switch that is next to the top of the door. looked for how to remove it easily done in ten minutes works fine last long time.

installed new part easy

Popped rail off and replaced with new one. Video showed how to do it. A bit tight to remove and just needed a little strength and patience.

I did not do the repair yet, there is no schematic on how to route the hose; also no description of how to do the routing/connections.

use kitchen knife to pry out. replaced switch assemble and pressed back into place. Could not have done this with out help from previous customers. Thanks

I unscrewed the support and replaced it with one that I ordered. It was fast and easy.

First I removed all food items from above and in the Meat drawer. Then I removed the meat drawer from the slides and placed it on the counter. Then I removed the shelf that the slide rails are attached to and turned it upside down on some folded towels. Next I inserted a screwdriver (Flat tip) between the bracket and the rail I am about to remove. This released the locking tabs. Then I slid the old rail back and it popped off. I install the new rails without the screwdriver inserting them in the slots and sliding them into place. Next I reinstalled the glass shelf back into the fridge. Finally I inserted the meat drawer back into the new slides. The Job went rather easy, just take your time and don't pry the screw driver too much, just enough to clear the locking tab.