Models > GT2123NEHW

GT2123NEHW Maytag Refrigerator - Overview

Get Parts and Repair Help for GT2123NEHW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GT2123NEHW, or you can search by name or part description. You can also find your part by where it is located on the GT2123NEHW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GT2123NEHW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$3.76

Crisper Drawer Shelf Support

This crisper drawer shelf support is used for many refrigerators.

$105.64

Fresh Food Door Gasket

This white gasket is used to seal the door when closed to keep the cool air inside and the room air out.

$2.70

SCREW

Sold individually.

$22.27

BLADE-FAN

$4.46

Hinge Washer

$4.46

Lower Hinge Pin

This lower hinge pin is just over an inch long. It is black in color and is made of plastic. It is located on the bottom part of the door hinge.

$58.71

Freezer Door Handle

$31.88

Clip -On Defrost Thermostat

This thermostat cuts out at 38 degrees Fahrenheit. The thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater o...

$3.96

Light Guard

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

cocktails running out of ice

  • Customer: Craig from Westminster CA
  • Difficulty: Very Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 49 of 54 people found this instruction helpful
filled both ice cube trays up with water and placed in the freezer.. within hours my ice oproduction was doubled! no more warm cocktails : ) read more

Coils frozen in refrigerator

  • Customer: robert from Martinez GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 22 of 32 people found this instruction helpful
Cooling coils froze up. Removed back panel in freezer section. After thawing coils, manually advanced defrost timer to check if fan stopped and defrost (heat) strips energized. Fan did stop, but heating strips did not energize to thaw coils. Used electrical meter to determine circuit was open at defrost thermostat. Ordered replacement and installed in about ... read more

Door seal worn out, needed replacement

  • Customer: ROBERT from BASSETT VA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 13 of 14 people found this instruction helpful
To make instalation much easier, I removed the door and layed it on a table. I then remobved about 45 screws,removed the inner door section, removed the seal and installed new seal in reverse order being careful not to over tighten the screws. Having the door lying on the table made it much easier to place the gasket in place and make any minor adjustments. ... read more