GSH25JFTAWW General Electric Refrigerator - Instructions

It was incredibly easy to repair. I removed the handle section from the old drawer and snapped it into place on the new drawer. It is as good as new! No tools necessary!

I watched the repair video and followed along pausing the video as needed to complete the steps. I'm not sure I could have done it without the video. That was wonderful. I will definitely order any parts I may need for other appliance repairs from Parts Select and utilize the amazing repair videos.

Replaced trap door

It was amazing , i didn't know how to repair , i had. Insurance from choice home warranty but they say it is not covered , i was upset with them . But i get partselect .com . It is very easy, i tell my problem they tell what parts i need and also saw me video how to install it , i just did with a screw driver in 15 minutes . It was wonderful experience and a lot lot easy then what i thought. Thanks to partselect team and webside.

Although there were many steps to the repair process it was relatively simple due to the excellent on line video. A link to the video was provided with the shipping confirmation. Thanks

There were only 3parts listed to check omed out the defrost heater and thermostat ....thermistor checked bad ordered replacement took less than 2 minutes to replace after I defrosted it again runs fine

Adding a small amount of water to the filter would resolve the problem for a week or two. So, I thought this was an issue with the filter and decided to try the bypass cap to help zero in on the problem. The bypass cap had no instructions concerning the need for O ring so it was trial and error. The O ring was not needed. After installation of the bypass cap, no water flow resulted and I had to replace the filter. Intermittent problem continues.

Replace old auger with new one.

Watched your videos, ordered the parts, installed them and wallah, it is working great.

Removed power, removed control panel cover, removed control board, installed new control board.

I watched the video and then read the instructions. Emptied and cleaned freezer compartment. Removed old unit and removed part of old unit to be used in new installation. I then installed the new unit and turned the water back on. I let the unit produce over night and through the first batch of ice away. Because of the various regrigerators this ice maker was used I had a little confusion recognizing our model, but worked through this problem useing some common sense. All around I'm very satisfied with the results.

Simple easy to follow instruction, very easy removal and installation. But for someone without mechanical skill, I dont see it being as easy as it was for me.

I determined that the auger was broken. But with company coming in a week I did not want to take a chance with needing additional parts. I simply ordered the whole assembly. It arrived in plenty of time and installing it was easy. Take it out of the box, rinse it out with warm soap and water, dry it out, remove the old bucket and slide the new one in its place. Absolutely no problem! I was surprised on how well the new ice dispenser worked after the swap. My old one must have been broken for some time.

When I clicked on the part to see it's description the pop up window included a youtube video on how to install the part. The video was right on the mark. Very easy installation. Phillips screwdriver was the only tool needed. Repair performed in less than 15 minutes. I have used this site before and it has been extremely helpful in saving me money by doing the repairs myself instead of paying an arm and a leg for a repairman to do it.

We had been told at some point the main control board would need replacement, due to various system issues with the refrigerator. The total repair cost would have been close to $400. The cost of the board was less than half of that cost. The instructions provided by PartSelect were very good. There was also a video of a similar model of refrigerator that outlined and showed every thing step by step. I removed the screws from the access panel in the back of the unit. unplugged the electrical plugs, removed the board. Installed the new board, reinstalled the plugs (all were idiot proof as PartSelect indicated), reinstalled the access panel and plugged the refrigerator back in. It has worked like new since install. This is an excellent website and service. I will use it again as needed with all my appliances.