GS6SHAXMB00 Whirlpool Refrigerator - Instructions

Hardest part of the whole project was figuring out how to get the bezel off the door to expose the problem area. The rest was simply removal and replace parts. The actuator arm had epoxy on it from the attempted repair and had to be replaced. Easy fix. If you can use a screwdriver and pay attention of how it comes apart you can do this.

Watched the video provided, then followed that procedure. Everything now works fine, no more clicking.

Our ice maker would work a few days then it would freeze up because it ran to much water in. I finally called Parts Select. The gentleman found the correct parts right away and I had them in two days. Took about 30 minutes to change out with a new unit. Only cost about 120 dollars. If I had known it would of been that easy and that cost effective I never would have took the time to un thaw it so many times with the blow dryer. Buy the new one, quick repair and gets rid of the head ache. Besides you will have ice when you need it. Good luck

Before I began I unplugged the electrical at the wall outlet. 1. Unscrewed the 4 mounting screws. 2. disconnected electrical at the motor. 3. removed the assembly. 4. mounted the new motor on the assembly as described in the instructions. Installed the assembly and reconnected the electrical. Works great, easy job!

Took ice maker out all together we removed 4 to 5 screws had to remove axel to get the broken piece out and new one in my husband said it was easy in and out in about 15 minutes saved about 150. 00 Thanks partslect

I simply replaced the old broken crisper drawer with the new one. Simplest repair ever.

After plugging in the new relay to no avail. I replaced the thermostat. That fixed the problem.

Replaced the Ice Maker Control asssembly. Online video instruction were ectremely helpful. Time to repair was about 10-15 minutes and we have a funcioning ice maker again!

A bit of a tight squeeze for my hands, but very basic as I followed the instructions and watched the installation video. I only had the fridge unplugged for about 20 min..The fridge is as quiet, as it was brand new. The only tool I needed was the 1/4 inch socket wrench. A portable lantern was very helpful as well. Runs very quiet now, like new! Thx!!!

ground off the extra tabs (part had 3 lock tabs; mine had only one). Had to tap the part into place with a hammer; could not install by hand only as the video stated

The video on your web site is great!! I had removed old ice maker and found that the main drive gear was broken off. Rec'd new one in 2 days remove bottom cover to put on new ice maker reinstall. Thanks for the help and great service!!! Tom

Fast after a little help from a friend

as per your video

Read the suggestions of possible repairs on PartSelect web site. Ordered part based on these suggestions. Part was received within two days. Followed installation instructions found on the web site. Part was installed within fifteen minutes. Ice bin was full the following morning.

Opened the freezer door. Removed the ice bin from the freezer compartment. Removed with a nutdriver the two screws holding down the shaft holder (the triangular white plastic piece). Removed the shaft holder and the circular seal underneath. Pulled the hexagonal metal shaft up and out of the dispenser motor. Installed new circular seal and reinstalled the plastic shaft holder, etc..