GLTF2940ES0 Frigidaire Washer - Instructions

Removed two screws, installed new piece.

Took the back off the machine. pulled out the old shocks and installed the new. Put the back on. Simple

Easy repair, buy shipping took much longer than advertised!

replaced door handle

I read other problems, I jumped the gun and purchased the door switch, this was easy to change, but MY machine still had the same issues, however, I found that the filter was plugged, and after I cleaned this out, this fixed my issues and the machine works fine, So I now have a door switch and striker should mine go bad, Hope this helps out

This is a front loader and the video I saw was a top loader. I removed the oval shaped centerpiece off the back to reach the pump. I also removed the filter and cleaned it, I used screw type hoseclamp in place of the tension spring for easier assembly due to the cramped space. This helped the drain problem as did cleaning the filter. The no spin problem persisted and I ordered the door lock part. This part fixed the no spin problem.

the existing pin was in backwards and to get it out was a problem because there was not enough room behind the pin to get it out.also i thiugh there was 2 pins in the kit and there was only one.

Take a deep breath and say, "I can do this. I will not pay well over $100 for someone else to come and do it."! Identifying part easy, mail very quick, web instructions clear, took out two screws, slipped out old part, put in new one, replace screws. I loved every minute of it and it cost $16.20 (part and shipping). Thanks, Part Select!

Removed two screws on the back of the washer top to release the top on the washer. Slid the top off and removed it. Opened washer door and removed two screws securing the door lock assembly to the washer frame. Reached in from the top of the washer to get the door lock assembly. Unplugged the old door lock assembly in three places and plugged the new assembly in in the same three places. Placed the new assembly in the same place as the old one and secured it to the washer frame with the same two screws located on the inside of the door. Replaced washer top and secured two screws at the top back edge of the washer... Tried the spin mode and everything worked great!!!

Unscrewed two phillips head screws, removed damaged part, screwed on replacement part. Presto! Washer works again. I especially appreciated receiving the part less than 48 hours after I ordered it with only regular shipping charge.

I shut off the water supply and started a cycle to release the pressure on the valves. Unplugged the power. Removed the top by unscrewing two screws on the back. Unscrewed the water lines and snapped off the plastic retainer for the water lines and overflow tube. Disconnected the wires to the red, green and blue valves, as well as the small black sensor on the side of the valve assembly. I had to unlock and partially disconnect the overflow tube to allow me access to one of the mounting screws. Removed the other mounting screw and separated the valve assembly by pulling it firmly. I put a little silicone grease on the two rubber mounting grommets and inserted the new valve assembly and re-assembled screws, wire harnesses. Replaced the top and screwed it down.

I am a 64 year old female that had never attempted to fix anything. This was my 1st attempt at fixing something. It took longer to look for phillips screwdriver than it took took to repair it. Thank you so much for instructions.

Simply removed the old broken handle screws and replaced it with the new one.

Good

Took cover off bottem on front of washer and pulled pins out of shocks. Put new shocks in and put the pins back in and reinstalled the cover. It was a easly fix and looking up the parts needed and ordering them was made easy by PartSelect.