GLMV169FPBA Frigidaire Microwave - Instructions

Determining the root cause was fairly simple - but one should always identify the basic repair part first that may be the root cause - in this order - Diode - HV Capacitor - Magnetron due to costs of fixing the issue. I found that after replacing the two major components it may have been just the Diod/Rectifier a low coat resolution - but one never knows if the issue was one or many problems that wouldn't allow the Microwave to heat. The team at PartSelect was very helpful and was able to expidite the Magnetron to my residence to start the repair process KUDO's to the Customer Service Team!

Open existing microwave door, Remove door interior trim, Lift door above hinge holes, Move top hinge pin away from microwave, Move bottom hinge pin away from microwave. Remove replacement door interior trim, Set bottom hinge pin in bottom microwave hinge, Set top hinge pin into top microwave hinge, install door interior trim, close microwave door and check closing. Door would not close completely to allow microwave operation.

My husband did it by just taking off the panel on the top of the microwave and replace old with new. We cleaned up some of the accumulated grease as well on the microwave. He had a little problem with the screws. We have done this before so no big problem. Thanks

After trying to bend parts that do not bend I realized you need to remove the plastic gasket around perimeter of microwave door but leave it loosely hanging on (pry off with screwdriver) With the gasket removed you can fit the door on and the snap the gasket back in place before closing and testing. The door was a perfect fit, it works great. The door will not go on until you remove or bend back that gasket. It's not obvious how or where to remove but just put a screwdriver in there and you'll feel it pop out and it snaps right back in after assembly..

on the inside of the door we gently pried off the liner to get ot the hinges ,lifted off the old door, place the new one on ,then carefully popped the inside liner back in place. Door fixed