GLMV169DSB Frigidaire Microwave - Instructions

I managed to move the auger far enough to allow me to insert the cup-drive and then realign the auger with the new cup-drive. I also have had one to break very shortly after installing it. This is my second part to replace and this one went really smooth, since I understood that the initial parts installation instructions did not apply on my ice maker.

Slid old one out and slid new one in (under tabs).

Remove, unscrew, the broken pieces. Install the new grill using the existing screws. NOTE: The grill was held in place with two screws, but there were three holes. The simplest fix would have been moving one of the screws to the hole where the plastic wasn't broken. One screw might have been enough..

Determining the root cause was fairly simple - but one should always identify the basic repair part first that may be the root cause - in this order - Diode - HV Capacitor - Magnetron due to costs of fixing the issue. I found that after replacing the two major components it may have been just the Diod/Rectifier a low coat resolution - but one never knows if the issue was one or many problems that wouldn't allow the Microwave to heat. The team at PartSelect was very helpful and was able to expidite the Magnetron to my residence to start the repair process KUDO's to the Customer Service Team!

My husband did it by just taking off the panel on the top of the microwave and replace old with new. We cleaned up some of the accumulated grease as well on the microwave. He had a little problem with the screws. We have done this before so no big problem. Thanks