GHW9150PW4 Whirlpool Washer - Instructions

I watched video first and it help me a lot to do the repair myself of my washer machine and i save about $ 1,500 dollar. Thanks

Repairs were very simple. Turn off the electricity to the machine. Remove approx 5 screws in the back of the top cover. Remove the cover and the micro prossessor is located towards the back of the machine. Very easy to get at. Just unplug the wires one at a time from the old one and place it into the new one. I also took a picture of the wires on the old processor before I started just in case I messed up. Put the cover back on the washer and it worked great.

I looked up the repair on YouTube. The exact repair was there. Remove the ring around the boot. Remove the part of the boot by the latch. Remove the latch. Replace the latch . Refit the boot. Replace the wire ring making sure the spring is down. Taadaa! The guy on the video took two minutes or so. It took me seven because I was very deliberate in my work, and it was the first time I had done this repair. The wife was very pleased!

My son pulled the washer out and found the parts that was leaking. He ordered the parts from your company. they arrived the next day and he re-pared the leaks and all is well.thank you

The product came on time and was perfectly rapped , it took me 15 mins to install after watching you tube videos on front loader washer . I was happy I didn't have to call a service man in . . . .

2nd screwdriver I tried worked fine. unscrewed the broke one and replaced the new one. very simple. We take good care of our house items and i,m so glad when you can get parts years later.

remove old worn parts , there was a little difficulty removing one screw due to rust but otherwise it went well.

pulled the front and top of the machine off, pulled off the old bellow, ordered the new bellow, and put the new bellow on. we looked on youtube.com for a video on repairing the machine.

Gave handle to husband who installed it in less than 15 minutes. Your service was great!

Very easy repair, once I read the reviews and watched a couple of you tube videos. I just released the band holding the gasket in place, pulled it back, unscrewed the latch and installed a new one. Less than a 10 min job. I am glad I found this web site, thanks guys!!

Took the brokern door handle attachment support screws off with my power drill in less than 10 seconds and intalled new handle in 20 seconds using the same power tool. Washer was ready to go.

I followed the instructions and it was surprisingly simple. Glad I didn't call the "handy-man" since it was easy to do it myself as a handy-woman!

Took both the screws out on the top back. Lifted up the back about 1/2 inch and slid to the back. Reached into the front of the washer where the latch was connected. Disconnected the 3 wires (plugs) attached to the latch, took out the 3 screws located inside the washer door. Took a second person just to hold the latch and bring it out after the screws were off the front inside the washer door. Put new latch in, connected the wires, put in the screws behind the washer door (3 of them) and slid the top into place and put the screws in the back. Takes longer to tell you than to do it. Remember the screw on the left side front (top) as you face the washer and remove that screw. The plastic had disintegrated on mine but am not going to replace that part until I have to.

We hired a local repairman and he even had trouble . I would not suggest anyone trying this installation on their own. It took the repair guy an hour to do and he struggled. Not an eary installation

The part was the right one, so it consisted of 2 screws out and two screws in. 3 minutes total. I needed to use an Allen wrench instead of a screwdriver, as was advertised.