GHDRE527H1WW General Electric Washer - Instructions

replaced drain hose and the water leak stopped. i could not see a hole in the old drain hose and thought i needed a new clothes washer but since a new drain hose was under $20. including shipping I figured it would not hurt to replace the old drain hose first. There must have been a microscopic split in the plastic drain hose because now it does not leak a drop. it was easy to replace and only took about 10 minutes from start to finish. Thanks.

Replace

Just traded out the hoses and installed washer and started washing. Also got the replacement hose in a very timely manner, in turn only without washer for 5 days total. Thank You

removed screws from control panel. pulled panel back to reach control valve and removed two screws holding valve. found that freezing caused one valve to leak. pushed valve back and reinstalled. That did not work so ordered a new valve, installed it and all worked find. don't forget to unplug washer from electricity and turn off water supply. Also the garage
floor needs water spill removed asap as the water froze on me and made it difficult to remove.

remove screws from bottom of washer to remove the bottom of the washer so you can access the pump and motor assy. and remove two hose clamps.

"Thought" the belt was the problem - ordered new belt - waited for belt to arrive - opened washer. Belt was in perfect condition - problem is the clutch. Next time husband will verify problem before ordering parts.

Changed the dual water inlet valve.

First i removed the bottom of washer and removed clamps from two hoses connected to the pump , removed 2 pump bolts along with wire connector. Then reinstalled new pump, hoses and wiring and that was it. Very easy !

New dual water inlet valve.

I took the two screws out that was holding the bracket and hose in place. I then pulled the hose out and then had a little bit of a hard time taking off the bracket (it was plastic and felt if I bent it to hard it would break) wiggling it down to the end of the hose. Re inserted the hose attached bracket, and I was done.
It would have cost me a lot more then $20.00 to have a repair man come in and fix it.
Love the service, delivered in two days.
Will use them again.

removed top and replaced .

Pulled off front cover of machine. Unplugged unit. Used a channel lock (water pump pliers) to squeeze the hose clamp on the suction hose. Pulled hose off of pump suction. Did same for discharge hose. Some standing water came out onto floor of unit. Unscrewed 2 screws from base using nut driver. Pulled the 2 wires off of the stabs of pump. Re-installed new pump in reverse order. Unit back on line in 15 minutes, and works fine.

R & R drain hose

The staff at parts Select are one of a kind, my order came before expected. Thanks Parts Select

Replaced the button and was working in less than Fifteen Minutes.

Unplug washer, turn off water and remove the supply hose, remove 5 torex screws remove panel disconnect two wire plugs remove 2 philips screws squeeze hose clamp remove old valve install new valve reversing directions