Enter the code DIYDAD10 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on June 17 at 11:59pm EST.
You've Got 10% Off Your First Order!Save 10% with code at checkout *click to copy coupon code
This is a lower rack roller for your dishwasher. It attaches in the lower roller assembly on the bottom of your rack to allow the rack to smoothly slide in and out. This replacement part is 1.5 inches...
$13.15
In Stock
Order within the next 5 hrs and your part ships today!
This part is a replacement gasket for your dishwasher. The gasket creates a seal at the bottom of the dishwasher tub, so water does not leak out while the dishwasher is running. If you notice water le...
$8.56
In Stock
Order within the next 5 hrs and your part ships today!
This is replacement door latch for your dishwasher. The door latch is attached to the tub frame, and connects to the door strike to keep your dishwasher door closed during operation. If you have a bro...
$44.31
In Stock
Order within the next 5 hrs and your part ships today!
The tub gasket, also known as the door gasket runs along the perimeter of your dishwasher basin and creates a seal that prevents water from leaking out when the tub is full. If you notice water on the...
$21.63
In Stock
Order within the next 5 hrs and your part ships today!
This lower spray arm assembly in your dishwasher distributes water and detergent during the washing cycle by spinning around and spraying water in different directions. You can usually find it attache...
$19.76
In Stock
Order within the next 5 hrs and your part ships today!
This dishrack is for dishwashers. The dishrack holds the dishes in place during the dishwashing cycle. Follow the instructions in the manual when installing this part.
$82.45
In Stock
Order within the next 5 hrs and your part ships today!
This is a flood switch assembly for your washer. The flood switch controls the hot and cold water filling your washer tub to ensure the proper amount of water. You may need to replace this part if you...
$54.03
In Stock
Order within the next 5 hrs and your part ships today!
The element heating assembly is found at the bottom of the dishwasher tub, and helps to warm the water in the wash cycle, and dry the dishes afterward. If the water does not heat up during the wash cy...
$56.37
In Stock
Order within the next 5 hrs and your part ships today!
This is an end cap for a dishwasher rack. This part is about 2.5 inches long, is black, and is made of plastic. You may need to replaced this part if it is broken, or if your dishwasher rack continuou...
$14.31
In Stock
Order within the next 5 hrs and your part ships today!
This mounting bracket is manufactured to secure your dishwasher to your countertop. Mounting brackets should be installed so the dishwasher doesn’t tip forward. You can fit the bracket to either the c...
$7.50
In Stock
Order within the next 5 hrs and your part ships today!
This is a washer inlet valve assembly for your dishwasher. This valve allows water to flow into your dishwasher at the proper rate. If your dishwasher tub is not filling with water or filling when the...
$32.48
In Stock
Order within the next 5 hrs and your part ships today!
This dish rack is for dishwashers. Dish rack holds the dishes in place during the dish washing cycle
$91.44
In Stock
Order within the next 5 hrs and your part ships today!
Questions And Answers for GDF520PGJ2WW
Ask our experts a question about this model and we'll get back to you as soon as possible!
10 questions answered by our experts.
Sort by:
< Prev
1
2
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim
January 7, 2020
I have replaced the door latch switch and the mother board , turned power on and still the washer does not work
For model number GDF520PGJ2WW
Hello Jim and thank you for writing.
Control Panel Reset
When powering down the unit and turning it back on doesn't work, it may be best to reset the control panel's computer. This is done by pressing two buttons, one after the other, at least five times each for a total of 10 presses. The door must be completely shut while the buttons are being pressed. We hope this helps. Please contact us anytime if you require further assistance.
5 people found this helpful.
Was this helpful?
Thank you for voting!
Martha
December 3, 2019
My lock control is on. What is the causing it?
For model number GDF520PGJ2WW
Hello Martha, Thank you for the question.If turning power off to the appliance does not allow the lock to release and unlock, you may need to replace the Door Latch PartSelect Number PS6447681. Hope this helps!
Unit is not heating water or drying dishes. Water was off for a main break and wife tried to run' i was going to replace heating element and limit switch. Something else i should look for ? Thanks for your help
For model number GDF520PGJ2WW
Hi Steve. It is likely the heating element. Thank you for your question and good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Wayne
March 19, 2023
The circuit board is bad and needs to be changed
For model number GDF520PGJ2WW
Hi Wayne, thank you for your inquiry. According to our research, the part you are looking for is part number PS16762498. We hope this helps!
Hello Gayle, Thank you for your inquiry. Check first to make sure that your dishwasher is getting power, test the power source, then remove the front panel below the door and examine the wires for any visible damage. If your dishwasher is controlled by a wall switch, make sure the switch is on. Next make sure the control panel is not locked by pressing and holding the heated dry button for 3 seconds or hold the steam and wash temp buttons at the same time for 3 seconds. We then recommend checking the door switch, power cord and power control board. Good luck with your repair.
Took off the kickplate, diconnected the wires and removed the whole door by lifting straight up, removing spring wires from hinges. Once door is disconnected from the machine, removed one hinge by removing bolt. Slid gasket into place, secured hinge back in place, then reconnected wires at bottom, replaced hinge spring wires and slid d
... Read moreoor back down onto hinges. Now that we know how to do it, could do it in 15 min to half hour.
We tried cleaning out the filter and it clogged with a huge amount of gunk. We removed the gunk, scrubbed the filter, and tried running the dishwasher, but still no water. That took over an hour (not counting the time the dishwasher spent running). Then we tried your diagnosis center and it pointed to the flood switch or the water valve.
... Read moreI extracted the flood switch (another 30-60 minutes) to check it, and it also contained gunk and (significantly) did not rattle, which made me suspect the flood switch was the problem, so I ordered one. Once the replacement arrived, I checked it and the flood switch rattled, confirming that it should work properly. I spent 30-45 minutes installing it, plus the filter assembly and racks I had to remove to access it. Ran the dishwasher and everything came out sparkling clean. I don't know where the gunk came from, but if you aren't getting water and the filter is full of gunk, check the flood switch.
1. Turn off breaker supplying power to dishwasher in electrical panel 2. Open dishwasher door 3. Unscrew the screws that secure the dishwasher to the counter. 4. Tip dishwasher forward. Identify the non-functioning door latch. It looks exactly like the replacement. Unclip the wire harness from the door latch. 5.
... Read more On the inside of the dishwasher, there are 2 screws directly under the door latch. Unscrew them and carefully set aside. 6. Remove old door latch. 7. Set new door latch in place. Holding securely, replace screws removed in step 5. Toward the end they get a little tougher to screw in. 8. Plug wire harness into new door latch. 9. Re-align dishwasher and re-secure to counter in previous position. 10. Test latch to make sure it closes properly. 11. Turn on breaker in electrical panel. The dishwasher should now function properly.
