All Installation Instructions for Maytag Refrigerator GC2228EEDB

Loose hinge cover

Replaced by snapping in new part

Parts Used:

Freezer Lower Hinge Cover

Ron from San Antonio, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Broken ice bin drive ring

Easy disassemble removing screws to separate front of ice bin.Be sure to note how metal rod is attached to rear of ice bin. Installed drive ring and reattached face (front) of ice bin in about 15 minutes.

Parts Used:

Ice Bin Drive Ring

James from Lincoln, NE
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Frost in bottom freezer, freezer 8%, ice maker works

replaced electric control board, defrost for six hours. next day (24 hours) same problem, dusterhoff2928@charter.net

Parts Used:

Door Switch

Richard from Smyrna, GA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

Was this instruction helpful to you?

Thank you for voting!

Compressor would not run.

Replacement parts looked different than the originals, however with the on-line feedback from similar customers and a well worded OM, the repair was quick and simple. Thanks to all.

Parts Used:

Relay and Overload Kit

Chad from Lexington, KY
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Water Dispenser didn't shut off immediately when glass was no longer pressed against actuator pad

We followed the directions in the video on the Parts Select website.My husband thought it was so easy and he isn't handy. I agree.

Parts Used:

Ice and Water Dispenser Actuator Pad

Sharon from Sugar Grove, IL
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

broke shelf on fridge door

simply popped out the old shelf and put in the new shelf with the little hooks that held the shelf with gravit

Parts Used:

Refrigerator Door Shelf Retainer Bar

kathy from West Bloomfield, MI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

My refrigerator light did not work.

After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.

Parts Used:

Door Switch

Fred from Warwick, RI
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

I broke the plastic cover for the egg tray in my refrigerator door

I ordered the part. It came and I popped it in. What made me so happy is the ease of finding the part I needed on your website as well as its speedy delivery! Thank you!!

Parts Used:

Dairy Door

Pauline from Milliken, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Natural door closer and lower hinge pin worn out

Did all of work without removing door. Door is approximately 2 1/2" off floor, so shim door with a piece of two by four and wood shims to hold door level while removing bolts. Had mirror lying on floor underneath the hinge to see location of bolts. Removed 3 bolts that hold the metal bracket. After removing the bracket the pin slides out. Then remove another bolt from the door closer, this enables the old closer to be removed. Then replace new closer with one bolt. Slide hinge pin back in place making sure tab is toward refrigerator to line up with hole in metal bracket. Replace metal bracket with bolts. Tools used were 1/4" drive ratchet, 1/4" drive 3" extension and a 1/4" drive 5/16 " socket

Parts Used:

Natural Door Closer

Lower Hinge Pin

Sylvia from Roxboro, NC
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

Was this instruction helpful to you?

Thank you for voting!

freezer normally functioning, refrigirator side too warm

I watched the instructional video included with the shipping date e-mail(about 3 minutes long), and simply followed the instructions. It took about 2 days for the refrigirator section to return to normal cool temperature to the level set.

Parts Used:

Air Return Cover

Joseph from Hamburg, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Ordered ejector arm.

No instructions with part. Found a picture on line and changed the arm, but it didn't fix the problem. Fairly easy after figured out what needed to be done to get to the part.

Parts Used:

Ejector Arm

Joyce from Springfield, MO
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Fridge Door Was Not Sealing Properly

I removed three screws from top hinge. Lifted door off bottom hinge and set door on a flat surface. Replaced part and set door back in place. Put screws back and door fit tight again.

Parts Used:

Natural Door Closer