GC2225GEK3 Maytag Refrigerator - Instructions

I unscrewed the old filter and screwed the new filter in the way the instructions said. I have done this before with no problems. Easy fix.

Screwed new filter in

empty frezzer take door off unplug wires going to ice maker unscrew/bolt icemaker replace door take motor cover off ice maker remove screws on motor replace ice cup and put every thing back together

followed instructions on box

Changed bulb, not the problem, had to remove switch to identify correct choice to order (3 pronged verus 2) after that it was easy beyond having to stand on my head to make the exchange. (N B before removing old switch it actually came back to life)

removed the broken bin, which was extrememely easy and set in the new one, equally as easy. The telephone staff were extremely helpful, and courteous, especially John, who took a great amount of time helping me find the correct part. Thank all of you.

Finally got the right part (two tries - had to call and get the right one, parts catalog for model showed different kick plate)

I opened the cover to the filter and screwed the filter counter clock wise until it came loose then removed the old filter and put the new one in. It was real easy.

I had watched my handyman take the old auger out realign it so I knew pretty much what to do, that adjustment did not work so I had to order new auger. Problem was lining up the screw holes, metal to ice box, just did not want to work. After about an hour of trying realized that the nylon grooves t the bottom could be slid in from each side after the holes were matched--hard to explain. Being female seems to take us longer to think this out.

It was very easy, just unscrew old filter and screw in the new filter. Reset the warning light, and done. Ralph Mason, 403 Sundance Lane, Georgetown, TX 78633

Refrigerator completely quit due to suspected power surge as a result of daily afternoon thunderstorms. Quit means compressor would not run, LED temperature controls would not light, but fan continued working. First, replaced Start Relay & Capacitor located attached to compressor. This was successful and compressor immediately started. However, Refrigerator controls at Electronic Control Board (ECB)failed to light up indicating no control over over unit. Replaced ECB and unit lit up and control established. The Start Relay & Capacitor are slightly difficult to find as they are black in color and merge into the base of the compressor. It helps to be flexible to remove and replace this unit due to it's difficult location. The ECB is easy to access as it is top inside front behind lights of unit. Plastic housing simply unsnaps for easy removal. Instructions do not tell you to make sure that you re-install the upper narrower control board with press pins toward outside of control face. A simple item but easily overlooked as one has to "pull" at the connecting cable of the two control boards. Success finally after three days. Parts Select was great and item shipped quickly. As a contractor, one can usually figure cost of job at three times the cost of the part. This repair would have approached $600. Cost of parts was $200. Savings were substantial and would recommend DIY provided you have time.

Repair was simple. Only problem was the screw holes weren't completely drilled through. This caused a little damage to the new ice bucket while driving the screws. Damage is minimal and ice bucket works.

Thanks to some reviews we found online about replacing gaskets, ours went very smoothly. One person said to soak the gasket in hot water, which we did til it was very soft. Installed like a breeze. Then, the same person said to tape the door closed after installation, we did that too. The gasket looks like it was professionally installed and we have never done it before. Thanks!

Easy unscrew remove and install new filter

I've been messing around with the old part for literally years. Every now and then the metal agitator rod would spin out of the plastic cup that joins it to the freezer. I'd have to disassemble it and try to get it back into alignment. This time nothing worked, so I ordered a new assembly. It arrived even more promptly than PartSelect predicted and it installed in five minutes. I couldn't be happier!