GB5525PEAW1 Refrigerator - Instructions

Removed the storage bins. Removed the whole shelf, remove the glass part.(clean everything while you are at it, which is why it took 15-30 minutes) Lift out old rail and replace it with the new, reinstall shelf and glass. If you choose to not to clean, just take out the glass shelf, replace rail and put it back in. .

Unplugged appliance. Using a small putty knife I moved the switch out far enough to grab it with pliers. Moved wiring to new switch and pushed into place after testing.

Move unit away from wall. Wrap ratcheting tie-down straps around top and bottom doors so they won't open when tilted. Lean unit back and place a 4 x 4 under front legs. Lean unit forward and place a 2 x 4 approx. 7 feet long against back of strap for top door to hold bottom of unit off floor, place other end of 2x4 against corner where wall meets floor. Adjust this distance, if needed, by placing more spacers of the floor until rear of fridge is almost 3" off the floor. Feel under bottom for 4 #25 torx screws on each side. Remove back 3 screws, loosen last (front) screw so metal base pan tilts down enough to lift compressor. BE VERY CAREFUL LIFTING COMPRESSOR, COOPER LINES CONNECTED TO IT ARE VERY FRAGILE. Remove fan shroud, remove drip pan, part of it is on the same stud the compressor is on.Replace pan, Set compressor back on studs, if the big plug on the left side of compressor became unplugged, don't bother to try to plug it back in until you replace screws of bottom metal pan.Replace fan shroud. Replace screws in bottom pan. Plug in big plug and hold-down strap on compressor if it came undone.

removed glass shelf then took broken frame out a cover and humidity levers had to be removed and put on new frame they don't come with frame it just sits inside the fridge on tabs then put crisper drawers in frame is all plastic and will break easily do not overload drawers not made to hold a lot of weight that's how mine broke

followed the video as instructed. Saved two repairman calls, one to find the problem, one to install. Net savings was about $130.00

1)pry out the old/defective light rocker switch with a screw driver (flat head) and pull out the cables 2)unplug two connectors at the end of light rocker switch 3) connect new light rocker into two connectors 4)push the wires inside and put back new light rocker switch

Removed two screws, replaced slide, put same two screws back in. Install drawer back in fridge. As my daughter would say, "Easy Peasy Lemon Squeezy."

I did exactly as the video showed. I popped out the old switch, disconnected the two terminals, connected the new switch and put it back. The light now works! The refrigerator is over 25 years old and the switch works! What a great website this is. Couldn't of done the job without Partselect's help.

Unscrewed screws, replaced handle, screwed it on.

followed instructions given; simple fix!