Models > FWX445LBS4

FWX445LBS4 Frigidaire Washer - Overview

Get Parts and Repair Help for FWX445LBS4

If you know the washer repair part you need, you can browse the list of all parts on the FWX445LBS4, or you can search by name or part description. You can also find your part by where it is located on the FWX445LBS4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for FWX445LBS4 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$12.71

Drive V-Belt

This belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

$17.91

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$33.09

Washer Lid Lock with External Safety Switch

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

$61.18

Remote Style Pump with Motor

Use this with either a top load or front load washer. This pump has an horizontal mount.

$10.10

Tension Idler Pulley

This idler arm assembly comes with the pulley wheel.

$46.50

Tub Seal Assembly

This seal helps prevent any leaking around the transmission of washing machines.

$4.45

Leveling Leg

$23.57

Selector Knob

This white knob accepts a D-shaped shaft.

$5.27

SCREW

$17.97

Drain Hose

This part comes with a ninety degree elbow.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

replace broken drive belt

  • Customer: rodney from fairfield bay AR
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 124 of 141 people found this instruction helpful
carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run... read more

PUMP MOTOR FAILED

  • Customer: Thomas from Walpole MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 37 of 39 people found this instruction helpful
First, remove the 2 screws that hold the lower front cover in place, remove the cover and disconnect the plug and the ground wires from the pump. Next attach the washing machine drain hose to a wet vac, since even if the machine is empty, there will still be water in the outer tub and the pump. Suck the whole thing dry, remove the 2 bolts that hold the cover... read more

Washer wouldn't spin.

  • Customer: garland from Morganton NC
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 38 of 50 people found this instruction helpful
The problem with my very old washer was that the tension spring had broken long ago and I had jerry-rigged it in place with a cable tie. It would work, but you had to give the drum a spin by hand when it hit the spin the cycle. This probelm further caused the premature wearing of the drive belt, due to slippage. I ordered both a new spring and a new belt.... read more