FEF366ECE Frigidaire Range - Instructions

We turned off the power then unscrewed the element . After removing the element from the connectors we taped the wires to the oven so as not to lose them back into the holes. We attached the new element, pushed the ends into the holes and refastened the nuts. Very easy and now we are back in business.

I watched the video on your web site, and it couldn't have been any easier. This is the second major appliance that I've repaired using this web site, and your instructions have been perfect each time, as well as parts cost. I can't get parts at any lower cost including shipping! Excellent resourse here!!!

repaired in 5 minutes with my nut driver. So, so, so easy to make this repair. And never even attempted to call an electrician. Since long before I became an official widow, I say...who needs a man...

Unscrewed the two screws which held element in place...pulled straight out...gently pulled connector terminals off....replaced with new element connecting element terminals ...sliding element back into place (make sure terminal connection is straight (ie NOT BENT) when pushing element back into original position)and screwing screws back in...DONE!!! EASY PEASY!!!

removed the screw at the mount on each side of element .pulled old element straight out untill wire connector was out at the back of oven ..unplugged wire connector from each end of old element ..plugged wire connectors back into new element .pushed element plugs back into back of oven and installed each screw that holds element into place.. real simple

The video was a great help. I could have replaced the switch without watching it, but it gave me confidence that I was doing it right. Everything went just like he said it would. Burner seems to work better now and no more scary noises.

Replaced the oven probe because a no heat problem. also had to replace the oven control. That was a bit expensive but still saved me hundreds not calling a serviceman. By the way, it works like new.....

aftering watching your repair video the repair went very well we took the oven door off to make access easier. the worst part of the repair was getting the door back on.

Undo the two nut screws pulled out the element and replaced it with the new one.

Followed instructions on YouTube and Frgidaire website. It looked easy; was easier than it looked -)

Removed old element by taking out two screws at bottom rear of oven. Pulled element and wires forward from two holes and unclipped from wires. Clipped new element to wires and pushed the wires back into the holes. Then replaced the two screws. Needed flashlight so that 60+ eyes could see the screws and holes in the oven. A quick and inexpensive repair. Element was delivered very quickly.

open door,throw the door latches at the hinges and remove door. Take the out of the outer panel so you can separate the glasses. remove clip that hold the outer glass in place. I ordered a replacement glass as I never thought that it would come clean it looked so bad, but it cleaned up like new so I now have a spare glass for my oven door. Just reverse the way you take it apart to put it back together.

removed the door from the range. removed the 4 layers of glass and carefully set aside the unbroken ones. the 3rd and 4th glasses were held together with a metal frame which had to be dismantled. The old broken glass was rusted and hard to get out of the frame. It had to be cleaned thoroughly of broken glass and rust. the removal process could then be reversed to assemble the parts and re assemble the door to the front of the range

i watched your video and removed the screws that held the element in replaced the element and was back in business--it would have been nice to know that a 1/4 nut driver or a square inverted socket was needed but i managed--parts were here in 2 day--very impressed--i will order from you again when i need to do another job

Turned the powwer off. Took out the two screw that held the element in place. Unhooked the wires off each side. Put new element in place hooked up wires and put the screw back in. Turned the power back on.