EER3001H00SS General Electric Range - Instructions

Like the others, the element is easy to remove. Just 2 bolts. However, the wires attached to the element are very short on this appliance and if not extremely careful, they will pop back into the insulation. I was half careful as only 1 popped back. I secured the 1 wire with a small clamp and removed the central panel in the back of the range (5 bolts). I worked the wire back into the oven, attached both to the element, attached the element to the back of the oven, neatened the insulation in the back, and replaced the center panel. It wasn't difficult.

Followed the example picture on the part bag. Anyone could do this, incredibly easy. Took about 4 minutes to install both sides.

For someone who does not do this often, the directiions walked us through it well. Saved big service call. I helped him hold the unit in place and he was able to connect the connections, and it works! But it was awkward to get to.

pulled these off and pushed off the new ones. This company is great - knobs fit - good price - stove fixed.

I ordered it online and it came to our house in less than 24 hours which is very impressive since we live in a very remote place. There were responses from other people who had the same problem and what they had to do to fix it which was very helpful because we knew what might happen. The wires went into the back of the oven when the old element was removed. We were ready, opened up the back of the oven and stuck it back in, connected it, cleaned behind the oven while it was out, put it back, and it works like new. Thankyou so much!

Unplugged range popped the switch out the front and one wire came off and fell down in there but was able to get it out with a pair of needle nose pliers and then snapped the switch back in after putting the wires back on

Per the instructions... I just wish I had read them first... It took me 10 min longer but it all turned out right and a LOT cheaper than calling the repair man.

I wanted a third rack in my oven to speed up baking. This is already serving that purpose for me. No trouble at all and very fast delivery!Thank you!

remove two bolts in on sensor and slip thru back un plug and reverse to put in

after reading instructions on this site , i knew to take the 2 screws out of the element in the rear of the oven. As soon as i saw the wires i put the clamps on them so they wouldn't fall back into the wall of the oven, then i just pulled off the old element and pushed on the new. Put screws in with nut driver and turned power back on.

First I unplugged the range. Then I removed the hex head screws, disconnected the two flag connectors and removed the old element. Then I reversed the process with the new element. I plugged the range back in and set the control to broil. It works like a charm!

Pulled unit away from wall with help of husband and followed instructions.

Followed directions that I found on the internet and it was easy to remove the old burner and replace it with the one I ordered from you. There was no problems at all.

Repairs went well. By the way you guys rock! From the easiness of your website to receiving the part a day ahead of schedule! We are baking again.

Very simple fix, after unplugging the range to shut off power, there were two screws to remove on the inside of the oven, and also removed the panel from the back with only four short screws.. the fix was simple and cost a lot less than what I would have paid to purchase a new range... The part arrived shortly after the order was placed...