EER3000K01BB General Electric Range - Instructions

Installed new guides with a nut driver without any problems.

Dear PARTSELECT

My experience with you was spectacular!!!!

The oven broiler burner went out on a Sunday afternoon while my wife was using it to cook for our family dinner. We ordered it that day and it was received, installed, and working on Tuesday afternoon...



How could it be any better?



Thanks



George Crady

Removed 2 screws that held the element to the back of the oven, took off the wire connections and did the same in reverse. . . . .

Went to the rear of stove took off bolts attach, slipped the old element out and inserted the new one then re-attached the bolts.

Repair was easy. 1. Turn off the electric to range. 2. very carefully remove the door(makes it real easy to access inside the oven.) 3. remove the 2 screws but be careful. 4. remove the two push on teminals. 5. The wires are very very short so they snapped back into the back of unit. 6. pulled out range and took off the 5 screws holding the small metal piece protecting all electrical wires...7. found the two terminal wires and push them on new terminal leads. 8. screwed the elements two screws back in, 9. replaced the small back with the 5 screws. 10. cleaned the floor behind the range and pushed it back in place.... DONE.... element works fine...tested it. however not cooking with oven today with temps outside at 104-105 ...will wait till it gets a little cooler... but all in all it was a piece of cake.....

Very easy to fix with two people and works great

Took out the old control module and removed the sticker and reattached sticker to new part and installed the plugs, put the screws back in and it started working, thankyou so much.

The only tool needed was a nutdriver to remove the lamp socket. I needed my head mounted light to see what I was doing, and everything went smoothly from there. Simple job.

remove rear panel cover, removered four screws that held control panel, disconnected colored wires, removed circuit control board, reinstall new board and connected color coded wire to the correct spot on the board, plugged in 220 volt cord, switch on circuit breaker, everything worked normal again

When I removed the unit I failed to secure the clip on wires - AND zing they went back into the insulation - now it required pulling unit out removing the back panel and placing wires thru the insulation and back into the oven - job was then very simple

Per the instructions... I just wish I had read them first... It took me 10 min longer but it all turned out right and a LOT cheaper than calling the repair man.

remove two bolts in on sensor and slip thru back un plug and reverse to put in

after reading instructions on this site , i knew to take the 2 screws out of the element in the rear of the oven. As soon as i saw the wires i put the clamps on them so they wouldn't fall back into the wall of the oven, then i just pulled off the old element and pushed on the new. Put screws in with nut driver and turned power back on.

First I unplugged the range. Then I removed the hex head screws, disconnected the two flag connectors and removed the old element. Then I reversed the process with the new element. I plugged the range back in and set the control to broil. It works like a charm!

Parts arrived in record time and the right parts. The detailed diagram was so helpful in finding exactly the part I needed to order. Was so easy my girlfriend with no mechanical or electrical experience completely helped me through the entire project. She secured the electrical breaker to the range, and I had the top back to the oven removed. I showed her how the little white box simply slides off the lens cover, then replaced the new one in the holes and slide it back on. Secured the back and she turned on the breaker back on...and all lights work. Thanks for making this project easy, simple and quick.