EER2001M01SS General Electric Range - Instructions

Took door apart to clean inside of glass door. scraped most of the wax from the stove 99%. Could not get the last 1%. Cleaned all parts. Put door back together again, put the door seal on after I got the right one. Had to reorder a new seal(one that was actually made for that model) messed up the first one and whalla! Took about 3 weeks to clean off the wax from stove and the surrounding area. Stove is good as new. Thanks for the quick service. Would definitely recommend and use you guys again. Thank You.

replaced insulation

Instruction were very easy to follow.

I simply removed the 2 anchor screws in front of the stove and wrote down the wiring order on the instillation diagram, removed the old burner, removed the two studs, made sure they were installed on the right numbers place them in the new burner, wired the new burner, placed the springs respectively. Placed them in the correct holes in the frame to be sure that the burner was aligned properly. Put the washers on the studs and replaced the frame screws, lowered the cook top and returned the screws to lock the cook top in place.

Like the others, the element is easy to remove. Just 2 bolts. However, the wires attached to the element are very short on this appliance and if not extremely careful, they will pop back into the insulation. I was half careful as only 1 popped back. I secured the 1 wire with a small clamp and removed the central panel in the back of the range (5 bolts). I worked the wire back into the oven, attached both to the element, attached the element to the back of the oven, neatened the insulation in the back, and replaced the center panel. It wasn't difficult.

Followed the example picture on the part bag. Anyone could do this, incredibly easy. Took about 4 minutes to install both sides.

I ordered it online and it came to our house in less than 24 hours which is very impressive since we live in a very remote place. There were responses from other people who had the same problem and what they had to do to fix it which was very helpful because we knew what might happen. The wires went into the back of the oven when the old element was removed. We were ready, opened up the back of the oven and stuck it back in, connected it, cleaned behind the oven while it was out, put it back, and it works like new. Thankyou so much!

Turned circuit breaker off to range as recommneded. Removed 2 screws from old heating element using a nut driver after removing the two racks from inside the oven. Considereing others had noted the wire sometimes came off and had to be retrieved by removing the back panel, I removed the back panel using the nut driver instead of waiting to see if that would happen. I removed the back panel after sliding the range out for easy access. Back panel was removed using the nut driver on approximately five screws that secured the back panel. This step may not have been needed because the wires were secured snug on the heating element. Secured new heating element and back panel. Turned on power after tripping circuit breaker and noticed a bright red hearting element in range within one minute. Real simple repair quickly done minutes after delivery by UPS.