EDW6160N00SS General Electric Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
broken door handle actuator
Parts were easy to find, easy to order and arrived prior to the advertised delivery date. Instructions for replacement were easy to understand and in about 10 minutes the old part was removed, and the new one installed. thanks for your prompt and efficient company.
Parts Used:
-
ROY from CULPEPER, VA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
soap dispenser was not staying closed....
hubby had no prob replacing the new part!!YEA!!dishes are clean again!
Parts Used:
-
Erin K. from Las Vegas, NV
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The end cap came off the upper rack
Super easy..........just push it on and it should snap in place. No tools required!
Parts Used:
-
Mary Beth from Whispering Pines, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Missing parts
I just purchased a house just before it went on foreclosure and several parts to th dishwasher was missing. I went on th internet and came upon your web site. Having no manual I thought that this was going to be abut as much fun as stepping on landmines. I was surprised that I entered the model number and was able o get all the parts hat I needed. The replacement was easy but a word to the wise sometimes on wheels they sell them with the locks that hold them to the basket and they will have the same part number. Other then that a fun experience.
Parts Used:
-
Russell from Grand Prairie, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
3 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The old plastic filter's corner were bent up allow food to get into the plumbing going to the articulation sprayers and clogging them.
Remove bottom articulating sprayer and water fittings. Remove and replace filter
Parts Used:
-
Frank from Tinton Falls, NJ
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
16 of 50 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
bottom rack f dishwasher wheels fell off at every use
I ordered both new wheels and stud that goes in the centers of each wheel. It took longer to cut the bags open than to install them. Works like a dream and no sqeaking and dishwasher works better since it is the correct distance from the water rotation arm on the bottom of the washer! Wonderful experience by an all thumbs do it yourselfer!
Parts Used:
-
Linda from Tucson, AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
lost wheel
just snapped the new part in. couldn't have been easier
Parts Used:
-
Nicholas from Alexandria, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
SOmehow the upper rack end cap went missing. I needed to replace the cap so the rack would not pull all the way out and fall down.
I used needle nose pliers. I bent the stainless steel guide arm out so that I could insert the end cap. Once the end cap was installed I used the same needle nose pliers to "pinch" the guide arm back tight around the end cap. The end cap had premanufactured "notches" to hold the end cap in place once the guide arms are pinched down.
Parts Used:
-
BRIAN from Keller, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
0 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
missing screw for Spray Arm
Remove top rack stops, slide out upper rack from rack railing, turn over upper rack and attach spray arm using spray arm bearing and screw. Reassemble in reverse order.
Parts Used:
-
Russell from Rosharon, TX
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
0 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
handle broke not allowing to door to open sometimes
Removed top screws to allow the ability to remove control dishwasher control unit. Remove door parts & be careful how you remove them & put back the door parts the same way.
Parts Used:
-
Cary J from Lorton, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
4 of 17 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rate chewed drain hose up.
Removed screws that held dishwasher under cabinet...pulled out DW...removed old part...replaced with new....easier than falling off a stump.
Parts Used:
-
Christopher from St Augustine, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers
8 of 30 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broke Cable
Easy to install cable. Works great now. Hardest part was removing the two phillips screws. (really not hard)
Parts Used:
-
James from Burleson, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
2 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Keeper latch broken, handle actuator damaged
Removed inner panel, replaced failed parts, replaced panel.
Thanks for your fast shipping response. Parts were ordered on Sunday night, you shipped Monday, I got them Tuesday !
Outstanding.
Thanks for your fast shipping response. Parts were ordered on Sunday night, you shipped Monday, I got them Tuesday !
Outstanding.
Parts Used:
-
George from Lutz, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
1 of 13 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken detergent and rinse aid despenser
after removing the inside of the door and removing the screws that hold the despenser installing the new one I found that the door now leaked.Itdid not seat properly due to the new unit not seating properly are I had damaged the door panel. I then bought a tube of silicone and sealed the back and front of the despencer and now it works ok. short bottom door seal was returned when I found the leak was around the despenser
Parts Used:
-
james from richardson, TX
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The lower rack of the dishwasher did not roll smoothly
Snap the stub/axle into the wheel and snap the assembly on the rack. EZ! This solved the issue where the original wheels (through age) were falling off the rack and the rack would bump over the gap between the body of the dishwasher and the door.
Parts Used:
-
Michael from Ashburn, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!