E23CS78GPS1 Electrolux Refrigerator - Instructions

Took the part out of the box and slid it in to place. It fit perfectly!

I was able to replace the housing by only removing the front cover, the e-ring and washer and the 3 hex-head screws. I was able to work the old housing around to get the actuator arm off and then get it properly inserted into the new housing. Attach the new housing, IMPORTANT: make sure you get the fixed-blades and spacer assembly in the slot of the housing that holds them in place, replace the e-ring and washer, check that the actuator arm operates the door properly and replace the front cover. The videos can be helpful but these shortcuts will save some time.

Original unit had screw on lugs. After removing old unit, I unscrewed the lugs, cut the lines to remove the nuts and inserted them into the new unit. Everything was color coded so connection was simple. Reinstalled unit, cycled the ice maker several times only to discover the fill tube at in the freezer had frozen ice blocking the tray from getting water. Used a hair dryer to thaw out the tube, water flowed instantly. Very easy repair.

This site sent me an installation video along with my shipping confirmation details, by email. It was very simple to do after viewing the video.

I watched the video and followed every step as outlined. It worked perfect, until I reconnected the supply line to my triple water valve. I used the old compression fitting and the compression nut. I should have cut the line and installed a new fitting and nut. The water on the floor the next morning reminded me of that. So back out I went and replaced the compression fitting and it has been as good as new. The ice maker took a few cycles to work again, I think it needed to fill the line with water first. But I have a huge sense of pride every time I hear water dispenced or ice dump in the freezer. Thanks for the help and encouragement!

DID IT JUST LIKE THE VIDEO SHOWED. UNHOOKED ELECTRICS, CUT TUBING, HOOKED UP ELECTRICS THEN TUBES TO NEW PART. PIECE OF CAKE.

Very simple less then five minutes.

Unscrewed (loosen) screws lifted unit out unplugged electrical connection. plugged in unit hung on screws tightened screws and had ice in less then 1 hour. Rick

Had to replace with a whole new part, had to take it all apart to replace

Simply remove & replace
No tools required

Unscrewed tye top door bracket lifted off the door and popped on new bearing takes minutes to do. Takes more time to empty thenshelves beforentaking door off

Loosen two screws, unplug power, lift it off, put new one on and make sure water chute is correct place, tighten screws!

The noise was made due to a loose part. I took the refrigerator door off and replaced the closer plate and hinge bearing. This solved the problem.

it took longer to remove the food and all from the door than the repair. It was a very simple repair. two bolts to take the top hinge off, pulled the door off and set on counter, removed old, broken glide, slid new one in. I ordered both sides, but the closer plate was in great condition, so I didn't use it. put the door on, then the top hinge and now it shuts like new. total time to fix (minus taking the food out of the door and putting it back in) was about 10 minutes.

love this super easy remove two screws and replace thank you