E23CS75DSS6 Electrolux Refrigerator - Instructions

The video was very helpfull. They were fixing the same refrigerator that I have. I punched in the set pin on the old part. Removed the old part by prying it out with a putty knife. Inserted the new part and drove in the set pin. I was glad that PartSelect had my parts. The repair shop in Fort Wayne Indiana did not even show this repair part on their computer.

I removed the top cover then the top hinge and replaced the bottom bearing. The hardest part was getting half of the broken bearing out of the door cavity. I had to break it up with needle nose pliers to get it to come out.

We followed the online instructions and tah-dah it was working...

Removed top hinge; raised and removed door from lower hinge; replaced stop; rehung door.

just replaced the old broken one and put the drawer back .

First I removed the Item out of the trays located on the door Then I removed the two screws that held the door in place> Lift the door of its location lay it on a flat surface. Counter top on a drop cloth. Remove old broken bearing< install new bearing. Replace door, install screws. Like new. I am a female and I was very proud of myself.

This is an easy repair. Unplug appliance. Remove the old water valve by unscrewing it from the frame of the refrigerator. Disconnect the cables and all the water hoses. The hose fittings are a different type: clip off the old connectors from the hose ends and push the hoses straight into the new connectors till they fit solidly. Reconnect the cables and screw the valve back onto the frame of the refrigerator.
Unfortunately, my leak was from a hose, not the valve, so this didn't actually fix it.

took existing water valve loose, removed plastic water lines and reinstalled on new valve and installed new valve into refrigerator

Water was leaking so I replaced the entire valve and just followed the color codes and thats it. Plug and play.

I pull out the broken part by push the center pin thru and then rerome all the parts. I then positioned the new part in place and push in the center pin to lock. quick and easy.

Drove pins all the way thru supports & then pryed support off. Tapped new supports in place. Watch the vidio on installing new supports. I probably wouldn't have been able to get the supports off without the trick I learned to just knock them on thru. Took all of 5 minutes to replace 4 supports.

Watched the video and read some comments and from that it was easy

The old pins have to be completely dislodged (preferably with an awl) before placing the new crisper support. The new pin of the support should be driven easily into the hole on the refrigerator´s wall with a conventional hammer (carpenter type). If you find resistance while hammering on the pin, do not continue. This probably means that the old pin is still inside the hole and does not allow the new pin to go in.

it was a simple fix, all i had to do was remove 3 small bolts from top of door, set door aside remove 1 screw that holds door cam in place, install new door cam.hole job took about 15 minute's.

Due to the nature of the support deisign and installation which was unusual I watched the video on how to extract the old broken support and install the new one, odering the new part was simple as the view privided in the parts section was specific and and easy choice to make, cost was very minimal and I received it the next day due to my being in close proximity to the shipping point, thank you and my crisper is very happy and so am I.