DW860A Jenn-Air Dishwasher - Instructions

This replacement basket fit perfectly, is well made, and came speedily, as promised!

Take out old basket throw it away. Put in new basket. time: 20 seconds. It took longer to open the package. I'm guessing at the brand, and I'm not going to my other house to find out.

Not well! Could use some guidance. I replaced the shaft seal, shaft seal washer, "D" shaft "E" clips, solenoid bracket, assorted screws and the pull solenoid. When replacing the seal shaft I moved the "D" shaft to far and it disconnected the lifter from the drain flapper flapper assembly and flapper spring. Since I do not have, and was not able to locate in my area or on line, a service manual for this machine, I had to go by a parts schematic that I received on line from Jenn-Air. Consequently, I wasn't sure on the reinstallation of all these parts. Since the plastic lifter can only be installed one way on the "D" shaft, it is believed that the flapper spring arm goes between the two prongs on the lifter. After completing the assembly as described above, I now have a situation where the dishwasher will not drain. The pull solenoid seems to work as designed, but when it goes into a drain cycle, it will not drain. Any suggestions, thoughts, recommendations or a copy of a service manual for this repair would be appreciated. Bill

I opened the door of the dishwasher, pulled out the old silverware basket, and then placed the new silverware basket where the old one was. The whole time, I was imagining how much it would be to call up and appliance repair guy and have him do this.

simply replaced the ring and the water inlet injector, no tools need on that part of the repair

Lifted old one out. Set new one in.

Go to computer, log onto PartSelect, order part. Two days later, go to mailbox, open package. Go back to computer, log onto PartSelect, watch instructional video on how to install the part. Go to kitchen, do what the video showed you to do. Job done.

First replaced the door seal, that slowed it down substantially, but not totally. Next replaced inner door foam insulation strip and that took care of it, no more leaks. There was some corrosion evident after I scraped off the old strip, sanded that smooth with emery sandpaper and then installed new strip. Job done!

I just opened the package, pulled out the baskets, separated them and put them directly in the dishwasher. The video showed the part and size of the baskets which was very helpful. The delivery was EXCELLENT!!! I would purchase from PartSelect again!

Followed the outstanding video instructions. Your company is fantastic. Your attention to detail, the quick shipment (one day) and video ... stellar! We will be referring your company to all!!! Thank you!!!!

replaced with new gasket and it works great.

I took the old one out of the dishwasher and put the new one in. The new one is much nicer and heavier than the original one!

soap door latch gasket must be installed so that it's collar is below carved out area of the latch, or water will slip inside collar. wasn't sure about reservor o-ring so used a little "Great White" pipe dope ("non -hazardous") on the o-ring . Combo worked.

good just screwed in

Because mine is a portable dishwasher, I had to remove top first. the sides and back are one complete unit. the torque screws are in the front, 2 on top, and 2 in rear. Then the panels can slide back to access the spring. Replace the plastic piece & hooked on the spring. Reassemble in reverse order.