DU55CA-55 Magic Chef Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Spring that holds door closed
First, removed screws on bottom panel. On this model, everything was easy to see. Did not have to move the appliance at all. The left side wire was broken. Just removed the broken part, connected the new wire, and then the springs to it. No problem at all. Took about 15 mins.
Parts Used:
-
Bessie from Fruitland Park, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
10 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wouldn"T Drain The Water Completey
Removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. . . )
Parts Used:
-
clarence from ST LOUIS, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
4 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Knob retainers were broken and knob kept falling to floor.
-
James from Mt. Pleasant,, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
4 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door mechanism broken
First removed the two screws and then the bottom part of the door. Replaced the broken cable & eyelet assy with the purchased part. Connect the eyelet with the two springs which tied with door mechanism with other cable/eyelet assy. Done
Parts Used:
-
Chung from Petaluma, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
3 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
door spring broken
It was really easy- Loved the fact that you had a picture of the part needed on your website, it really made finding the part we needed very easy. I would highly recommend your site- the part came quickly, also
Parts Used:
-
Tracy from Montour Falls, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
2 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Pump seal elak
Removed motor and found shaft severely rusted. Cleaned up the rust but the shaft was too pitted to work effectively with the new seal.Wasted my time and money
Parts Used:
-
Richard from Northville, MI
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers
1 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Cable for door springs broke
Attached new cable and eyelet to existing springs. Took all of 5 minutes to install. Very easy. Works great.
Parts Used:
-
William from Philadelphia, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
Was this instruction helpful to you?
Thank you for voting!