DU1300XTVQ2 Whirlpool Dishwasher - Instructions

Checked to see if top spinner was clogged. All ok. Wanted to see if water was flowing from bottom. Checked a video to see how to remove parts to access lower area. Saw the problem immediatley. Clogged Chopper screen due to broken chopper blade. Ordered new chopper assembly and got it in two days. Five minuted to install. Washer works like new.

Estamated time was 15 minutes, it took me about 3 hours because everything was so cake up with detergent. Parts would not move. Video very helpful

Before I ordered the replacement part I carefully disassembled the front panel of the dishwasher,and I documented the placement of all parts and electrical connections using sketches and photgraphs. When I attempted to peal off the printerd electrical panel from behind the touch buttons the circuit board tore.Therfore I went on line to find a replacement printed circuit board. Without any difficulty I was able to order the proper part which arrived in aout 1 1/2 days. Except for the lack of directions I was satisfied with your service, and would reccomend your company to anyone.

Removed set screw from spray arm. Removed old bracket from washer basket. Attached new set screw in new bracket. Attached new bracket to washer basket. Done.

Ordered the gasket on line. Received gasket in 3 days. Removed old gasket by pulling out in one piece. Pressed the new one in with my fingers and it fit perfectly and now have no leaks. Very easy fix.

The service video was great. This is a great product web site and service.... Thank you

Just had to take several screws out of old panel on dishwasher. Used the same screws to put on the new stainless panel. No wires to disturb. Was very easy. Works like a charm. Thank you Parts Select.

put new one in

cap was replaced

I watched the Video that was supplyed with the e-mail and when the part got here I new just what to do and it took maybe 15 min at the most. You saved me over $100.00 from what we had to pay once before for the same problem to a repair man. And now I know where to buy my parts for all my appliances when they fail and with KitchenAid it seems to be quite often.

Old gasket was broken in places and old. Installing the new one was easy- no tools required. Just pull out the old one and press in the new one. Washer still leaks because door does not close all the way- need to figure out how to get it to shut tight. Maybe the latch is loose or worn.

The first check was for any circuit breakers that tripped. Upon finding the circuit breakers intact, I removed the front panel from the dishwasher and verified power was up to the panel, which is was. I removed the kick panel and located documentation for schematics and troubleshooting. This led me to the bi-metal switch (non-resettable). After turning off the power, I checked the continuity across the switch and found it was open. Then I provided a short across the switch and turned the power on to verify panel was working properly, which is was. This verified the bi-metal (thermal switch) was the issue. I then ordered the switch and installed it per the instructions. While looking for the switch, I did run across another post suggesting the additional wire leads with the kit should be included since they act as a heat sink. With the new switch installed along with the additional wire leads, the dishwasher is working fine.