DU1015XTXD0 Whirlpool Dishwasher - Instructions

Repair was easy. After readjusting the dishwasher so that it wasn't leaning forward (it still leaked) I replaced the Door Gasket. Pulled one end out about 2 ft and pushed in the new one as I pulled the old one out and pushed the new one in. Came out and went in easy, just used a big screw driver to slighting push the new gasket in to make sure it fit snug. Fit, Form & Function was all correct. Works like a sharm, no more leaks and door does fit snug when closing. All good.

Repair was simple. Pulled out the old gasket and pushed in the new one.

I first purchased the door assembly because the solenoid was fried. That was a fairly easy installation. Unfortunately the door still didn't open. I then purchased a new Electronic Control Board. The installation was again fairly easy. After killing the power I removed the (10) Torx door fascia screws. Then I removed (2) Torx screws holding the control assembly on. Support this assembly to reduce strain on the wires. Slip the two tabs on the left side of the board that retains it. Carefully remove all of the plug connectors. Then reverse the entire procedure and test.

Checked to see if top spinner was clogged. All ok. Wanted to see if water was flowing from bottom. Checked a video to see how to remove parts to access lower area. Saw the problem immediatley. Clogged Chopper screen due to broken chopper blade. Ordered new chopper assembly and got it in two days. Five minuted to install. Washer works like new.

Estamated time was 15 minutes, it took me about 3 hours because everything was so cake up with detergent. Parts would not move. Video very helpful

Removed set screw from spray arm. Removed old bracket from washer basket. Attached new set screw in new bracket. Attached new bracket to washer basket. Done.

Ordered the gasket on line. Received gasket in 3 days. Removed old gasket by pulling out in one piece. Pressed the new one in with my fingers and it fit perfectly and now have no leaks. Very easy fix.

put new one in

I watched the Video that was supplyed with the e-mail and when the part got here I new just what to do and it took maybe 15 min at the most. You saved me over $100.00 from what we had to pay once before for the same problem to a repair man. And now I know where to buy my parts for all my appliances when they fail and with KitchenAid it seems to be quite often.

Old gasket was broken in places and old. Installing the new one was easy- no tools required. Just pull out the old one and press in the new one. Washer still leaks because door does not close all the way- need to figure out how to get it to shut tight. Maybe the latch is loose or worn.