DU1010XTXQ2 Whirlpool Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dishes were not dry, flashing lights.
Pulled the dishwasher out, removed 2 wires and 2 plastic nuts, removed old heating element, installed new heating element, applied nuts, connected 2 wires pushed the dishwasher back in, drank beer (Per instructions on email - really liked).
Parts Used:
-
Randy from Port Byron, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
Not drying
-
Todd from Huntsville, AL
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Water dripping from lower corners
Removal and replacement of the gasket required no tools and took very little time. However, this did not solve the problem. I called in a repairman who determined the issue was the washer was not filling to the proper level. The control board was replaced and the problem was solved. This also quieted the washer a lot in that the pump was no longer sucking air.
Parts Used:
-
William from Mt Pleasant, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Original chopper assembly had broken, was rattling and debris was blocking pump to upper spray arms.
Repair was straight forward. The video description was excellent. Pay attention to where the chopper assembly sits in the cavity, there is a second location closer to the impeller, but this is not where it goes.
Parts Used:
-
Chris from Beaverton, OR
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!