DRSR483ED2WW General Electric Dryer - Instructions

This was a very easy job. It was like snapping Lego pieces together. I ended up taking more time because I took the time to clean the orher parts while it was open. Took about 30 minutes total. Please make sure you know where the electrical wires are located at the bottom of unit. If you take the whole front panel off some of the wires may come off. There is not much documentation on the wiring so be cafefiul. Take a pic if you can. I watched the videos on YouTube from this site before starting. Just want to add that I am not a mechanic of any type. This is an easy job.

We ordered the part and I remember coming to this website and reading the reviews. So when my husband came home we pulled out the dryer and we unscrewed the back of the top plate. We then took the needle nose pliers totake the wire off which there are three of them just remember when changing the switch where the red wire goes instead of going uotop it goes on the bottom. After that we were done and I would say that it took about 15 minutes. When doing this make sure unplug the dryer before you do anything.

Removed broken starter switch, replace with new one. Dryer worked like a champ. Fast and east R&R.

Found replacement part easily on website using model and serial number.Part arrived in one day, fit perfectly without any tools and dryer is functioning like new. Easy ordering process with excellent customer service.

Replaced the start switch and knob..first of all I unplugged the dryer (this is a must when replacing electrical components) then I took the two screws off the back of the dryer top cover and turned the start switch in a counter clockwise fashion. It popped off, then I unplugged the 4 wires and plugged into the new start switch. I then turned the switch onto the clips in the opposite fashion and it clicked into place. I then put the cover back on, replaced the two screws, pushed the knob onto the start switch, plugged the dryer back in and it started right up.

unpluged dryer opened door took out 2 screws holding the top lid on took out 2 screws that hold the front on replaced parts and put back together. Dryer sounds brand new.

With your drawings, we identified the part and my wife installed it by herself about 3 days after we ordered it. Great Service! Thanks

its very easy!! just pull or pry out the old handle clean surface snap in the new one! its that easy!! PS don't get to rough with the installation!!

Drum slide slots had worn so bad that i needed to replace the whole thing. I had already taken it apart before to change drum slides and knew it was a matter of time before the whole bearing was going to need to be replaced.

removed what was left of old door handle and replaced it with new handle. Snapped right in without any trouble, 30 seconds max.

just installed it

I checked out YouTube and found some really helpful videos from various appliance guys. The parts came fast and I knocked out the repairs in about an hour. Replacing the front and rear bearings was a breeze and no more squealing. Just like new

read and looked up the blown up picture of the dryer , got the correct tools and removed the two screws in the top of the dryer door , removed the top , removed the two screws on top going to the sides , then one screw in the front lower left side to allow the left side wall spread apart ,took the idler arm and belt off the motor shaft , picked up the drum with the belt and pulled it out forward. ordered the correct parts that were recomended . parts came the next day , instructions on your web page were awesome .. and it runs better then new !!!! thank you very much ! and i believe i saved a bunch of money !!

Went well. Excellent service on parts delivery .

Pulled out the dryer, removed all the screws to the top control panel. Removed the broken part, installed the new part. screwed it all back together and it was fixed. Anyone can do it