DP1040XTXB1 Whirlpool Dishwasher - Instructions

put new on and tightened correctly -was nice to get the right part the 1st time !

replaced gasket

Pulled the dishwasher out, removed 2 wires and 2 plastic nuts, removed old heating element, installed new heating element, applied nuts, connected 2 wires pushed the dishwasher back in, drank beer (Per instructions on email - really liked).

As directed online

Removal and replacement of the gasket required no tools and took very little time. However, this did not solve the problem. I called in a repairman who determined the issue was the washer was not filling to the proper level. The control board was replaced and the problem was solved. This also quieted the washer a lot in that the pump was no longer sucking air.

I knew I needed a faucet adapter, but thought I could just go to my local home depot and get the part...not so much. After 3 trips and not getting the part I truly needed I ordered the part from partselect. I received it literally the day after I ordered it, screwed in place with no tools, attached the coupler/hoses to the faucet and washed dishes. I wish I would have ordered the part from partselect before even bother with home depot. I would have saved myself a lot of trouble! Extremely happy! Thank you!

Replaced the faucet adapter, works fine

I cut the breaker and disconnected the in and out water lines, then removed the washer. Once on its side, I took it apart until I found what was broken. The chopper unit had broken and parts were sucked into the pump. After going online and finding/ordering all the parts, I cleaned everything and put it back together so as not to lose anything. When the parts came in,it was an easy job to replace the broken parts and have it back in use. The repair would have cost over $350 and my parts bill was less than $90. Thanks

Took out old dishwasher rack and replaced with new.

Removed unit from counter. Replaced element.

took the bottom sprayer off to reach the chopper assembly.Then took out the old one and put the new one in. It works like new!

removed broken pieces , replaced with new your diagrams and part info was perfect, just remove and replace

Empty dishwasher remove bottom basket. Disconnect electricity then turn off water. Remove top screws from counter. Slide unit out and gently tip forward. Remove the two wires from connectors on element. Unscrew plastic nuts from element save if reusable. Gently tilt unit back to normal position. Remove old element and install new one and attach to stainless spacers to hold element in place. Tip unit forward. Reinstall plastic nuts. Plug wires back into new element connectors. Tilt back into normal position. Turn water back on check for any leaks and repair if necessary. Turn electricity back on and then slide unit back into original position and replace under counter screws. Test out by running quick cycle wash. It should function normally. During drying cycle open door to be sure it is hot inside. If hot then it is repaired. Let it finish cycle and replace basket. Do not touch hot element as it will burn you.

I bought the portable dishwasher on Craigslist, and it didn't have the connector that goes on the kitchen faucet. Ordered it here, got it in a few days, and didn't need any tools - just had to screw it on. Good as gold!

After finding out how to replace it (on YouTube)the repair went smoother than anticipated. the difficulty was disconnecting/connecting the electrical(BX to electric hook-up to dishwasher) due to the proximity of where it was located(~1" from the floor). Other than that, the unit now works as good as the 1st day when it was bought(~6yrs ago)