Below is a list of all parts for the General Electric Dryer DHDSR46EG1WW - Electric . To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
Sold individually. There are 2 per dryer. They attach to the outer-most sides of the bearing. Manufacture recommends to replace both slides at the same time.
This knob accepts a D shaped shaft. Sold Individually.
This dryer knob accepts a D-shaped shaft.
May differ in appearance but functions same as original.
Note: The drum slides should also be replaced when your replacing the drum bearing.
Slides are NOT included. This part helps your dryer operate as quietly as possible.
This drive belt is 89.5" long.
This part is used to start the dryer once you have selected a setting on the timer. The terminal locations on the new switch may be different, match up terminal numbers from old sw...
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
This filter collects lint as it passes through the dryer vent.
Sold individually. This light bulb has a screw in base.
This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running...
This part is on the outer door of the dryer.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2015 , Eldis Group Partnership. All rights reserved.