DDC4400SHM General Electric Dryer - Instructions

All we had to do was snap it back into place on the door

It was as easy as the repair film said it was . But after spending the money for the upper and lower baring seals I put it all back together and the motor started making a loud noise ? I took the drum and everything out and started the motor without the drum just the motor was running and the danged motor is going out now !I checked the price of a new motor its not to bad but with all of the parts I have put in this thing I could have paid part of what it would have cost for a new dryer ! I put it all back together and hope it last long enough to at least recoup some of what I have spent ,But the new parts work good !

I followed the directions on the video I uploaded.

Replacing the door handle was a "snap" literally. All I needed to do was remove the handle from its plastic wrap; line up the inserts on the handle with the holes in the door and snap it in place. It was that simple.

Ordered new part, part came in, snapped in to place. Took less than 5 minutes, the hardest part was getting the part out of the package.

The replacement handle, though it didn't look like the handle it was replacing, fit perfectly. Simply put the 'hinge' parts in place and then snapped the handle right onto the dryer; a perfect fit. Same for the filter - removed the old one, took out the remaining lint/dust and replaced the filter with the new one. Took no time at all, and works beautifully.

removed the old broken handle, and snapped the new one in place, total time; 10 seconds.

Snapped on the new on the new one. all done

The repair went just as the self help video showed on your web site. Since I was replacing front air duct assembly, and had unit disassembled I figured on replacing upper portion, bearing slides (as recommended) and lint basket. Now it as good as new. Thanks for the help!

I watched the installation video a of couple of times and followed the instructions. Two screws under the dryer door then the top comes off. Then two screws hold the front on come out. Unplugged the two wires to the switch. Removed the duct assembly. Cleaned up the door and snapped in the new duct assembly. Re-installed the door and then the top. Everything was easy - just like in the video.