DBXR463ED2WW General Electric Dryer - Instructions

Found replacement part easily on website using model and serial number.Part arrived in one day, fit perfectly without any tools and dryer is functioning like new. Easy ordering process with excellent customer service.

Replaced the start switch and knob..first of all I unplugged the dryer (this is a must when replacing electrical components) then I took the two screws off the back of the dryer top cover and turned the start switch in a counter clockwise fashion. It popped off, then I unplugged the 4 wires and plugged into the new start switch. I then turned the switch onto the clips in the opposite fashion and it clicked into place. I then put the cover back on, replaced the two screws, pushed the knob onto the start switch, plugged the dryer back in and it started right up.

unpluged dryer opened door took out 2 screws holding the top lid on took out 2 screws that hold the front on replaced parts and put back together. Dryer sounds brand new.

With your drawings, we identified the part and my wife installed it by herself about 3 days after we ordered it. Great Service! Thanks

its very easy!! just pull or pry out the old handle clean surface snap in the new one! its that easy!! PS don't get to rough with the installation!!

Drum slide slots had worn so bad that i needed to replace the whole thing. I had already taken it apart before to change drum slides and knew it was a matter of time before the whole bearing was going to need to be replaced.

removed what was left of old door handle and replaced it with new handle. Snapped right in without any trouble, 30 seconds max.

just installed it

I checked out YouTube and found some really helpful videos from various appliance guys. The parts came fast and I knocked out the repairs in about an hour. Replacing the front and rear bearings was a breeze and no more squealing. Just like new

read and looked up the blown up picture of the dryer , got the correct tools and removed the two screws in the top of the dryer door , removed the top , removed the two screws on top going to the sides , then one screw in the front lower left side to allow the left side wall spread apart ,took the idler arm and belt off the motor shaft , picked up the drum with the belt and pulled it out forward. ordered the correct parts that were recomended . parts came the next day , instructions on your web page were awesome .. and it runs better then new !!!! thank you very much ! and i believe i saved a bunch of money !!

Went well. Excellent service on parts delivery .

Pulled out the dryer, removed all the screws to the top control panel. Removed the broken part, installed the new part. screwed it all back together and it was fixed. Anyone can do it

I followed the provided video precisely. Made the job quite easy. My only problem is I'm 6'2", 275 lbs. with bad knees. Can't go at it exactly as shown in the video because I can't squat down in front of the dryer without pain. Called in a neighbor of smaller stature for him to come from one side, and me from the other. Worked flawlessly. Video is excellent. I do recommend wearing gloves and/or long sleeve shirt. I cut up my arms a bit, but that could have been easily avoided.

replaced the parts that had worn out

Removed 2 Phillips heads on front panel. Removed 4 hex heads on back panel controller. Took off lid. Took 2 Phillips screws on inside by door out. Lifted door off. Discovered on front seal housing 2.5 of 4 seals gone. Replaced front seal bearing and lower felt seal.. A must...vacuum at all the dust! Replaced the green and white seals. Put all back together. My 17 year old dryer is like new again and quiet. Did this for $37. Front seal housing was fine so could have did for $20. Also thanks part select. I ordered at noon on Monday and had Tuesday at 5pm.