DBLR333EG2CC General Electric Dryer - Instructions

Watched the video and found it to be a very simple and easy installation.

Pretty easy fix with the removal of 4 screws, disconnected front panel , disconnected wires on front panel, removed top panel, once all panels were removed pulled out drum, while removing belt, removed damaged rear drum bearing held in place by 3 screws replaced new rear drum bearing, Removed light bulb, popped out plastic front drum bearing replaced 4 new drum slides on new front bearing popped it back in place, removed old felt strip, replaced with new felt strip, put it all back together front panel first, removed four screws on control panel to make the top panel easier to replace, and fired it up, it was as quiet as new, great videos that made the job allot easier and saved a ton of money to boot. Thank you for your quick delivery time as well..

I removed the drum from the dryer (the instructional videos on this site showed me exactly what to expect) and it got easier from there. The old O-ring on the rear bearing had broken and the sleeve was moderately worn, but both were easily slipped off by hand and replaced. As for the front bearing, the new slide plates inserted onto the edge of the new bearing plate easily. The old front bearing was badly worn, and except for one, all of the slide plates were worn to nothing. This was apparently the cause of the terrible squeaking noise. After removing the light buld and applying a little pressure, the old bearing popped out and the new one replaced it just as easily. You must remember that there are 4 slide plates that mount to this bearing and they are SOLD SEPERATELY! You have to buy 2 black ones and 2 white ones and each is sold individually. Once replaced, the dryer worked good as new! While I had the dryer apart, I removed all of the built-up lint from the exhaust line and the interior of the unit with my hands and a shop-vac. My dryer now runs squeak free and my drying times have decreased substantially due to the cleanout of debris. I highly suggest you watch the instructional videos on this site, they are extremely accurate.

first, I watched the helpful videos. I then removed the screws that are located inside the door and screws from for top panel to remove front and top panel. When I opened the front panel I saw that the front drum bearing was half destroyed from the years of drum rubbing. I Replace front drum bearing and slides and now dryer sounds like a brand new quiet dryer.

The repair went just as the self help video showed on your web site. Since I was replacing front air duct assembly, and had unit disassembled I figured on replacing upper portion, bearing slides (as recommended) and lint basket. Now it as good as new. Thanks for the help!

I watched the installation video a of couple of times and followed the instructions. Two screws under the dryer door then the top comes off. Then two screws hold the front on come out. Unplugged the two wires to the switch. Removed the duct assembly. Cleaned up the door and snapped in the new duct assembly. Re-installed the door and then the top. Everything was easy - just like in the video.