DBLR333EG0WW General Electric Dryer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Plastic timer knob broke and spun around freely
I grabbed the broken knob firmly and pulled it straight off. I took the new knob and pressed it firmly into place.
Parts Used:
-
Larry from Austin, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
broken door handle
removed the old broken handle, and snapped the new one in place, total time; 10 seconds.
Parts Used:
-
Paul from Mattydale, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
handle on dryer broke off
-
Diane from Torrington, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Timer knob would not stop or start the dryer in the correct place. Looking at the back of the knob, the D ring was cracked.
Bought both the knob and metal insert clip. Turns out that the clip was unnecessary as the knob came with the clip. The repair was quite simple. Simply pull out the old knob and insert the new, taking care to align the D.
Parts Used:
-
Bob from Lincoln, NE
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dryer was making loud noise when in use.
first, I watched the helpful videos. I then removed the screws that are located inside the door and screws from for top panel to remove front and top panel. When I opened the front panel I saw that the front drum bearing was half destroyed from the years of drum rubbing. I Replace front drum bearing and slides and now dryer sounds like a brand new quiet dryer.
Parts Used:
-
miguel from alvin, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
front air duct assembly broken @ lint filter
The repair went just as the self help video showed on your web site. Since I was replacing front air duct assembly, and had unit disassembled I figured on replacing upper portion, bearing slides (as recommended) and lint basket. Now it as good as new. Thanks for the help!
Parts Used:
-
J.R. from HAZEL GREEN, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The plastic grid behind the lint filter started cracking with pieces breaking off. This caused delicate clothes to get tangled and twirled on the broken pieces.
I watched the installation video a of couple of times and followed the instructions. Two screws under the dryer door then the top comes off. Then two screws hold the front on come out. Unplugged the two wires to the switch. Removed the duct assembly. Cleaned up the door and snapped in the new duct assembly. Re-installed the door and then the top. Everything was easy - just like in the video.
Parts Used:
-
Gilbert from Torrance, CA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!