Models > CVG4100B > Instructions

CVG4100B Jenn-Air Cooktop - Instructions

All Instructions for the CVG4100B
76 - 81 of 81
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
burner knobs were melted beyond repair.
Replaced the old knobs with the new ones.
Parts Used:
Surface Burner Knob
  • Thomas from Tucson, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The original filter was decomposing each time I washed it
I removed the protective grid over the filter and fan, turned the clip that held the filter in place and removed it. I placed the new intact filter for my antiquated Jenn-aire in its place, replaced the protective grid, and am happily continuing to cook on my functional cook top.Thank you.
Parts Used:
Grease Filter
  • Sharon from Kenai, AK
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
One burner knob melted and one had a broken "stem"
Pop off the old and on with the new. Took longer to open the plastic packaging each came in than to remove & replace old knob with new.
Parts Used:
Surface Burner Knob
  • Joan from Egg Harbor, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Nroken Burnner knob
Slide the knob onto the shaft.
Parts Used:
Surface Burner Knob
  • William M. from Rock Hill, SC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Filter worn out, exhasut fan kept going off
Old filter allowed too much air flow causing exhaust fan to go off....installed new filter in exhaust chamber...release clip on old filter and install new filter (at an angle) in the exhaust box....clamp down clip on edge of filter and job is complete
Parts Used:
Grease Filter
  • John from Cayce, SC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Front burners would not light.
First, unplugged the cooktop from outlet and shut off gas. Then, removed burner assembly then located and removed existing spark module. Installed new spark module kit, reassembled burner assembly and then plugged unit into electricity and turned gas on. Was rewarded when testing burners with an instant ignition.
Parts Used:
Surface Burners Spark Module Kit
  • Jeffrey from Columbus, GA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CVG4100B
76 - 81 of 81
Back to Top