CSX24XLC Hotpoint Refrigerator - Instructions

First I flipped breaker to off position for refigerator, Pulled down on socket and broke it free. Then took needle nose piars to pull wire and plug out from hole, so I could conect to new light socket then snaped it in place . Hardest part was getting wire and plug out of hole.

It was exactly as shown in your instruction video

Remove both lower drawers. Remove 2 screws form the broken slide. Position the replacement slide and tighten screws. Replace the storage drawers. New parts were delivered within 2 days.

I watched the video on the webpage and did as he did. it was quick and easy. didn't realize the importance of this little part until it broke

Took out the broken one and replaced it with the new one.

Buy new ones and screw them in. The design is seriously flawed, and it is necessary to keep a supply of side rails for replacement.

I did exactly as the video instructed. Removed the top hinge bracket. Removed the door. Replaced the parts on both the door and the freezer, taking care to save and re-install the shims. I put the door back in place and installed the top hinge. I also lubed the hinge pins with very light grease. The door now works perfectly.

Went well. Changed the Ice Maker and then the Water Valve. All good and it is making ice.

Removed broken light cover (that was held together with tape) and replaced with new part. The most amazing thing was that I was able to locate the part for a 21 year old refrigerator

After receiving the part (quickly) my son-in-law replaced the old one without any trouble. Thanks very much

Replaced fan motor

Recently changed the "under the sink" water filter because ice was getting really small-the filter was old. Ran great for a month or two. Then.....no ice. Water pressure ok. Even filled the ice tray in the ice maker and when frozen it kicked it out.....but no more. Repair took 15 minutes......pretty easy. When I called local appliance repair......they estimated it would cost $200-$250. My part was $44.

Pulled out old socket.pushed in new one.

I removed the front of the unit assembly and removed the entire auger unit and drive assembly. I married the old drive cup and new drive cup back to back using vise grip pliers, drilled 4 3mm holes, installed 4 phillips head stainless steel screws and, using an emory wheel, ground off the exposed screw ends. I then re-installed the drive assembly and auger unit. This increased the length of the drive cup allowing the drive to fit without any slippage. The entire cost was less than $18.00 including shipping and screws and took about 1 hour. It works great.

Watched the video that showed how to disassemble the ice maker. Then went right in and replaced the part and turned it on. It immediately started filling up the ice tray. I still have not been able to find out why it does not make as fast as the original ice maker. The tempeature for the freezer is set pretty cold.