CSX22BCBBWH Hotpoint Refrigerator - Instructions

Did the repair jut like the instructions on the web site stated. There was a good video for doing this repair. Looked at it a couple of times and did the repair right off the bat. Thanks folks.

replace the lower door hinge assy. and closer cam as a set.Only used a 1/4" socket and ratchet.The process was very easy without any problems.

Piece of cake and now I get loads of ice.

I followed a video supplied with the e-mail notification of the shipment of the part. This was one of the best experiences I have had with locating, purchasing and installing a replacement part for an appliance.

All thumbs, not handy and lacked confidence to even try to fix even simple problems. First, panicked! Next went to U-Tube and imputed Model number of Refrigerator and searched "freezer cold, refrigerator warm." Next, found U-Tube video which showed me how to diagnose, remedy and fix the problem. Determined the problem,and was directed by U-Tube to PartSelect. Searched part name and cost. Compared cost of parts with other part suppliers. Waited about a week to ensure my diagnosis was accurate, then ordered the part. Part came in about 3 days, went back to video instructions from U-Tube, opened area, took pictures and then replaced part. Since then the Refrigerator has worked perfect, let's hope it continues to work well, after this post. New found confidence and belief in my "Handy-Man" ability.

Followed instructions that came with time, also viewed the video of website.

I watched the how to video and followed the instructions. The entire repair took less than 4 minutes. Hardest thing was disconnecting the control panel.

Turned the appliance off, take the back panel off, defrosted the coils. Put a cork in the drain hole and a towel to soak up the water. Four screws take the heaters off, pull the thermostat from the top coil. Unplug the wire at the top. Install the new heaters, clip the thermostat on the top coil, route the wires around the side, plug in the heaters. Put the panel back on with four screws, turn the appliance back on. You may need to empty the ice container because it will thaw some and freeze back solid. Most of the time spent defrosting the coils

Followed the instructions. Smooth as silk. This part is better than the original. There appears to be a sensor that beeps when the ice reservoir is full.

Part came in on time, and the repair went smoothly - no problems

I followed the instructions on the youtube video on the company web page. I removed the cover by hand, removed the exisitng flapper door and install the new door, easy as pie.

Followed easy video instructions. Loosened the necessary bolts, etc. Replaced hinge assembly, lined up door, lubed the hinge with vasoline. Works perfectly now. May purchase another assembly as spare as it appears this may be a common repair issue.

Took the paper clip, pressed in through the holes on the bottom of the ice dispenser panel. Removed the four screws. Loosened the panel and removed the wires. replaced the flapper door. Then reversed the process. Your video was VERY helpful except for the paper clip. Had to get that off another web site.

Removed the old broken one with screw driver and installed new one with screw driver and voila all done!

did it just as the video showed. it was a little different, but absolutely nothing that we as ametures could not figure out! very easy and I think it was just the part we needed! biggest thing was unloading refrigerator!