CRGF342AS1 Frigidaire Dryer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
broken belt
it was so easy using the video that you emailed me. I want to rebuild my whole drier now .
Parts Used:
-
Benny from Long lake, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Loud screeching metal sound from the back when dryer is running
This video by Steve Ash was spot on . In our case the white rear support bearing had melted and reformed around the shaft, preventing us from being able to pop the drum in the way described in the video. We used pliers to unscrew the screws on the rear clip from the back of the dryer. The rest of it worked exactly as described in the video. Our model was White-Westinghouse DE600ADD1, which is not a model listed on the PartsSelect website. However the part worked very well. The dryer runs really quite now.
Parts Used:
-
Naraen from Kirkland, WA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers, Wrench (Adjustable), Wrench set
Was this instruction helpful to you?
Thank you for voting!
No reheat
Pried the lid up and flipped it back then disconnected the front panel wiring harness and then popped the front panel loose at the top and dropped it down. Disconnected the ignition coils, removed the coil retainer bracket and replaced the coils. Reassembled it in reverse order, performed functional test. Success!
Parts Used:
-
PETER from Fremont, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
brown stains on clothes
-remove screws on top of dryer -check for clips on side -remove panel under control panel -remove screws (6) I think, holding control panel -disconnect door switch connector -remove 2 more screws holding front -you may have to lift the tub to allow the vent tube to clear for front removal - - Proceed with felt seal portion of repair - - - -GOOD LUCK You may need help.
Parts Used:
-
James from Hiawassee, GA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The blower fan was loose on the drive motor shaft and rubbing against the housing
You tube has quite a few videos that walk you right through the entire process. Due to the age of my dryer I replaced the belt and the Rear Drum Bearing kit while I had it apart. There were videos for all of it. Easy fix.
Parts Used:
-
Darrin from Columbia Falls, MT
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
broken belt
The belt arrived in 2 days. I cleaned the inside and it took no time to replace the belt. All I did is removed the front.The video was very helpful.Your magnet is on my refrigerator for future orders. Thanks.....Andy
Parts Used:
-
andrei from Clifton, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!