CRE9590CCL Maytag Range - Instructions

I simply unscrewed and removed the old bake element. Then popped in the new bake element according to the directions in the Youtube video that was attached to my order confirmation email.

Before starting, shut off power to the range with the circuit breaker or fuse, or unplug the service cord. The bake element is the lower element. Remove the wire oven shelves for easy access. Using a Philips#2 screwdriver, remove the two screws holding the old element to the rear of the oven. Gently pull the element straight out until you can see the connecting wires come through the holes. These wires are connected to the element with spade clips. Remove the clips by pulling them straight off the old element taking care that they do not fall back into the holes. Put the new element in place, connect the wires to the terminals, and slide the assembly into the holes. Replace the two screws, restore the power and you are done.

Lifted the range top about 2 1/2 inches, removed the ceramic top and replaced the burner. Tested the burner before replacing the top. Everything worked fine.

Upon receiving the replacement part, I noted that the socket was held in place by simple expanding tabs. TURN OFF POWER TO THE OVEN. Using a right angle pick or similar tool, bend the tabs inward on the existing socket and remove. Disconnect the white, black and green wires. Note which tab is the green tab. Attach the wires to the new socket. Push the new socket into place, aligning the key bump on the socket with he slot in the oven wall opening. Install bulb and diffuser.

two philips head screws and pull straight out about 6 inches unfasten wire connectors. Be careful not to let insulation catch fire when you reconnect the two slip on connectors. Put the two screws back in and you are done

Remove two Phillips head screws , detach element , replace with new one. Very simple

I ordered the part on a Monday morning and I had it on Tuesday. (I used regular shipping) Took out the oven racks and unscrewed the element. I pulled out the element about 4 inches and disconnected the wires, and removed the element. I made sure the wires were not burned and that the connectors looked good. They did. I simply connected the wires to the new element and screwed it back in place.

I think the installation instructions are fairly self explanatory. This is the second item I've ordered from Parts Select and I'm thrilled with their service. The items are always less expensive than other sites and they deliver what they promise. I would highly recommend them.

Unscrewed three screws securing the glass top. Lifted glass top and wedged it open. Took a picture of the current wiring. Removed old burner.Compared male contact points on new and old burner. Plugged new burner in appropriately. Note: The new burner is MUCH hotter than the old one.

Removed stove from slot in wall. Bent rear left leg would not unscrew due to bent metal bracket. Used hacksaw to cut out leg, then straightened metal bracket with small hammer and was able to screw new leg in and adjust height by using level on stove before reinserting stove its slot. Recheck level after pushing back in place and adjust front legs if necessary. If not for bent metal receiving bracket, would have taken much less time. Still easy tho. R'cvd part in two days. Very quick.

Amazingly simple. Removed 2 screws, pulled off 2 wire terminals, removed broken element. Re-attached wire terminals, installed screws.......baked some cookies to reward myself. lol Actually, my girlfriend replaced this part. I just talked her through it. Thanks Partselect. I wasn't able to save you any cookies though.