Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Unit would run continuously and not shut off
Removed the front cover and then the humidistat from the bracket. Two push on wire connectors and then reversed. Very straightforward and excellent part matching. Given the prices for new dehumidifiers it was great to breathe life back into this unit which does its job well. Thanks for the easy to use web site and fast fast service!
Took unit outside removed the covers cleaned dust and lint out with high pressure air removed motor and tryed to repair it when this didnt work I took it in to my desk and ordered a new motor on-line, this was at 2:30 the next day at 10;30 the new motor arrived via UPS. I installed it and the unit has run fine ever since.
The float turned up missing during a move to another city.
The repair was just putting the float into the inside of the tank itself and then, inserting the two pins (left and right) into each slot so the float operates up and down freely.
The float has two prongs that fit two snap fasteners on the reservoir tank. I just pressed the float prongs into the snap fasterners and inserted the reservoir tank into the dehumidifier. Turned the switch and pressto! We are in business.
Remove the front cover 2 screws on the bottom. Then removed the clip for the full light, then removed 2 more screws that held the humidistat. Removed the 2 power wires removed part. Reverse the uninstall procedure. Done
First I pulled the top/side cover off. Disconnected the terminals from the old unit, unscrewed the old unit, and put the terminals on the new unit. Then I put the side/top cover back on, screwed the new humidistat unit into the front cover and then popped and screwed the front cover back in place. Customer service was excellent and order was received promptly as promised. Highly recommend Parts Select!
First I removed the two control knobs and the two screws that hold the front cover in place and then the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. Then I reconnected the new humidistat and put everything back together. Works just fine, now.
The difficulty was getting the motor out of the unit. It is held in by a snap-fitted support piece that gets in the way. After several failed maneuvers, I removed the fan from the motor (a job that would be easier if my hands were half-sized) and then extract the motor. Then the fan had to be replaced and tightened on the new motor. However, now that the job is done, I'm happy with the end result. The new motor runs quietly, and the unit is back in action.