Models > CDB4000TQ0 > Instructions

CDB4000TQ0 Magic Chef Dishwasher - Instructions

All Instructions for the CDB4000TQ0
181 - 192 of 192
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Heating element would not heat
I watched the video, read all the post, they all said change the heater. So I did. Only there is a little fuse at the back of the unit that also goes bad and that was my issue. Have it ordered and will be going soon. That said, Part Select made finding and getting my parts a breeze!
Parts Used:
Heater
  • Jim from Republic, MO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Water leaking from door
Just followed the online instructions. I used white vinegar to clean any residue first. So easy.
Parts Used:
Dishwasher Door Gasket - Gray Water Deflector
  • Kenneth from East Providence, RI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Rusting lower rack
Replaced the lower rack. The replacement part had the wheels attached. No assembly required.
Parts Used:
Lower Dishrack Kit
  • Todd from Sylvania, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
water leaking from bottom of door
removed the 2 water deflector and slipped the new ones in , in place.. very easy to do but it didn't seem to stop the leak so ordered the door gasket
Parts Used:
Water Deflector
  • Mary Ann from Menahga, MN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
top basket wheels worn out
used a common screw driver. took the ends off then pulled out the basket . used the screw driver to pop the brackets with wheels attached. new ones back on and about twenty minutes done. very easy.
Parts Used:
Rack Adjuster
  • Carl F from liberty, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Leaking where motor drive shaft enters pump
Remove lower rack in dishwasher, remove dishwasher, lay dishwasher on it's back, remove and replace motor and pump.Install new impellar with new seal. reconnect water, electrical and drain hose. Easy Peasy
Parts Used:
IMPELLER
  • Steven from Woodstock, IL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
the tips of the rack were rusting.
Received new rack in record time(very impressed with the delivery time)installed one part for the removable rack in the rear and simply replaced the old with the new.
Parts Used:
Lower Dishrack Kit
  • Gary Scott from Bonham, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Broken Hinge Lid Pin and Lid Spring
I followed the video's from Parts Select and it took me less than 3 minutes to replace these parts. I did find it easier to use a screwdriver to lift the u shape of the spring over the detergent cup as the pliers tended to pull on the spring too much. Couldn't have been easier or faster, awesome!
Parts Used:
Spring, Lid Pin (Lid Hinge)
  • Jan from Chatsworth, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Wouldn't fill with water
Instructions very easy to follow
Parts Used:
Water Inlet Valve
  • David from Eight Mile, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
Water not draining out of dishwater completely
I read everyone else's fixes, which were very helpful but my solution of removing the plastic from the motor shaft was a lot easier than others. I simply used side cutters and made two cuts into that plastic piece and it Fell of. much easier than the person using several Dremmel blades to cut it off.. That was the most difficult phase until I grabbed my ole phone company side cuts and just cut it off in 15 seconds. Thanks for all the other tips. I love dealing with Parts Select, Fast and efficient. Jim W
Parts Used:
IMPELLER
  • James from Lecant, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
dish washer soap drawer would not work
we followed your instructions submitted via e-mail and they worked out just fine....thank you
Parts Used:
Soap Cup Latch Kit
  • matt from grant park, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Leakimg a lot of water from under door.
Started down Parts Select list of possibilities. Replaced the door gasket (1/2 hour), still leaked. Replaced water deflectors (15 min), still leaked. Was looking at steam vent and read the repair submitted by "mary from Fountain Green UT". Removed and thoroughly cleaned the steam vent (1/2 hour). Stopped leaking and is working fine now. Repairs were very easy using Parts Select instructions.
Parts Used:
Water Deflector
  • William from San Jose, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CDB4000TQ0
181 - 192 of 192