CAM2752TQ3 Whirlpool Washer - Instructions

Easy as 123... unscrewed the top agitator, removed the parts and replaced. This part cost me about $3.00 and the repair call the last time was $250.00. I guess I would call it a profitable day!

Simply removed the agitator and replaced dog ears. Really easy!

After watching some on-line vids, I determined it was the center post, or tub, gasket at the bottom. A cheap part, and easy to snap-out the old and snap-in the new - But - I had to dissassemble the washer into individual washer component molecules. Luckily, I'd done this recently to replace the clutch drive, then the motor, then this. Not too bad, really. Washer body off (2 screws and two snap-links); agitator out (7/16" socket on extension); bang off tub nut (heavy hammer and punch); bang off drive block (hammer again); and pull tub up an out. Tub drain disconnected (pliers); pull off level sensing tube; three spring mounts (nutdriver); then just yank tub up. Poke out Centerpost gasket; snap in a new one; reassemble. Piece of cake.

After a little research on line, I knew to remove the fabric softener cup, pull out the clear plastic divider, unscrew the agitator bolt, pop off the construction clips, slide a plate down a bit, remove the old cogs, put in the new, return all the pieces to their places, screw the bolt back in place and now it works perfectly. I also bought a cabinet clip, spacer & screw that I will use at a later date. This repair went quickly and easily.

From the central column, pull off the fabric softener dispenser (of course, with the machine off). Reach in and pull out the seal (looks like a diaphram). Using a socket, undo the bolt and pull out the plastic ratchet assembly. I found the 4 dogs in bad condition, ordered them, and received them in a couple days. Replace the old dogs and reassemble. Only the bolt requires a tool. Much simpler and cheaper than I had anticipated.

replaced the agitator directional cap by simply removing the top of agitagor. unscrewing a bolt, slipprd off broken peice, slid new peice in place, and rescrewed it in. Voila washer runs and agitates as it should

Very easy - less than 30 min. Followed installation video available on PartSelect website, except did not have to disconnect all hoses or lay on back. Left washer in place all connected and raised up on blocks about 6" off floor. Removed cabinet as per video instructions. Changed pump as per video instructions. Video from website was crucial to easy repair. Would not have known how to release cabinet latches and remove cabinet without video. Cabinet was off in 3 min. and entire job was less than 30 min.

I pried up the top timer setting box. Removed two screws on the back pried up the two clamps and disconected the door sensor. removed the outer case and removed the water pump. Put all the parts back on reverse order and was back in working order.

Watched the video on how to repair the problem and did what was instructed to do and the repair was that easy.