Models > B4607X0

B4607X0 Roper Range - Overview

Get Parts and Repair Help for B4607X0

If you know the range repair part you need, you can browse the list of all parts on the B4607X0, or you can search by name or part description. You can also find your part by where it is located on the B4607X0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$37.77

Heating Element

This element carries 5200W and 240V. Note: This element no longer includes two terminals and two adapter leads. They must be ordered separately.

$30.71

Bearing and Seal Kit

This front bearing and seal kit comes with the adhesive.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$50.56

Infinite Switch Kit

This is a push-to-turn switch with a break-off shaft and plastic adapters. Can be used for either 6" or 8" elements.

$3.73

TIME ADJUS

$18.93

PIPE BRA

$3.73

BRACKET FO

Igniter (Broil. & Oven Burner)

Bushing-Reducer

Cushion-Oven Door (3 Req)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer quit heating. Suspected heating element was open

  • Customer: Bill from Morristown TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 145 of 163 people found this instruction helpful
Unplugged the 220 volt source. Disconnected the vent line from the back of the drier. Removed the six screws holding the back panel with a 1/4 inch nut driver. Tipped the drier up at a 45 degree angle against the wall to give better access to the inside. Removed the screws holding the two thermostats to the side of the heater box and laid them aside. Di... read more

Dryer was not heating

  • Customer: Frank from Fort Collins CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 56 of 61 people found this instruction helpful
This is the second heating element I have replaced in this dryer which I bought new in 1977. That's right it is 32 years old and still works great!

The replacement process is simple:
One: pull the dryer away from the wall so that you have room to work in the back.
Two: Disconnect the dryer vent hose from the back of the dryer.
Three... read more

Loads in the dryer took a very long time to dry often needing two full cycles to completely dry.

  • Customer: Rod from Galveston TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 43 people found this instruction helpful
First, I moved the dryer out where it would be easily accessable. I then removed the back of the dryer using a nut driver. Once this was complete, I removed the cover holding the heating element. I disconnected the two wires and puled the old element out. I replaced it with the new heating element and reconnected the two wires. I then replace the back cover ... read more