- Customer: Bryan from Chicago IL
- Difficulty: Easy
- Time to Complete: Less than 15 mins
- Tools Required: Pliers, Socket set
- 22 of 25 people found this instruction helpful
Water was leaking on the floor during the wash cycle and especially during draining of the washer. I removed the front panel at ground level and watched while draining after a rinse.
I t was obvious that water was spraying from a hole in the rubber end of the hose (the hose is a fused assembly of a plastic section and a rubber section).
- Customer: William from Fayetteville NC
- Difficulty: Really easy
- Time to Complete: 15 - 30 mins
- Tools Required: Nutdriver, Pliers, Socket set, Wrench set, Wrench(Adjustable)
- 17 of 17 people found this instruction helpful
I was doing laundry one day, and noticed that the washer did not drain. I drained the water via a shop vac and checked the hoses. There was a baby sock stuck in the hose leading to the pump! I cleared the jam and the washer finally drained again. Once I ran another load, the washer wouldn't drain. I repeated the procedure, and found that the motor was spinni...
- Customer: Brian from Okauchee WI
- Difficulty: Very Difficult
- Time to Complete: More than 2 hours
- Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
- 20 of 34 people found this instruction helpful
to replace the seals is the easier part of the job. I Removed the front panels and removed the front screws for the top and opened up. Then you have to remove the agitator, then the bell plug, the bolt holding the bell along with the bell, then the 1-1/2" nut under that. then slide the plastic washer that fits into the splne. to remove the drum you have to r...