Models > ALE230RAW > Parts

ALE230RAW Amana Dryer - Parts

All parts for models starting with ALE230RAW

Below is a list of all Amana Dryer parts for the models starting with ALE230RAW. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

Models starting with ALE230RAW

All Parts for models starting with ALE230RAW
1-14 of 100
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Multi-Rib Belt

At 93-3/8" in length, this flat dryer drum belt has 5 ridges and is 3/8" wide.


Drum Support Roller

This roller is for square-ported models and has a metallic bearing in its center. They are sold individually and most dryers use 2 rollers at the rear and it is recommended to replace both at the same time.


Drum Glide

This drum glide is sold individually. ***Please Note: these should be replaced in pairs.


Idler Pulley Wheel with Bearing

A dryer's idler pulley wheel serves to help the belt to rotate the drum.


High Limit Thermal Fuse

Meant as a backup to a high limit thermostat, this fuse is typically set to trip at a higher temperature than that of a high limit thermostat. This is a one-time use fuse, so when ...


Lint Filter

Note: This part no longer comes with the felt seal. This filter collects lint as it passes through the dryer vent.


Thrust Washer

This washer is 3/4 inches in diameter.


Idler Lever

The spring for this part is sold separately.


Door Catch Kit

This kit comes in two pieces: the catch and the clip.


Door Switch Kit

This part replaces older two terminal switches.


Cylinder Felt Seal

This part is located between the back of the drum and the rear dryer panel.


Heating Element - 240V

This orange dot heating element replaces those elements with an orange dot on the element flange.


Retaining Ring

Sold individually.


Limit Thermostat

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 225 degrees Fahrenheit. The element will kick back in when the temperature drops to 185 degrees Fahrenheit - the differential of 40 degrees.

All Parts for models starting with ALE230RAW
1-14 of 100