Models > AGC585E (P1142922N)

AGC585E Amana Range - Overview

Parts and Repair Help for models starting with AGC585E

If you know the range repair part you need, you can browse the list of all parts for models starting with AGC585E, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for AGC585E parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with AGC585E

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Light Bulb - 40W

Sold individually.


2 Piece Broiler Pan

The top of this part is now black.


Top Burner Spark Ignition Electrode with Retaining Clip

This part helps your burner ignite and produce flame.


Frame Screw

Sold Individually.



Sold individually.


Suface Burner Ignition Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.



This screw is sold individually.



Sold individually. This part helps your drawer glide in and out smoothly.


Leveling Leg

Sold individually.

Electrode Retaining Clip

This clip is well under an inch in diameter. It is made of metal and it will help secure a range's electrode.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

There was a crack in the porcelain not letting it spark

  • Customer: Billy from Martinsville IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 17 of 24 people found this instruction helpful
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire.
Then just connected the new electrode and place the assy, in the burner. read more

Ignitor did not spark when turning the know

  • Customer: Richard from Lansing MI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that attach to the oven light... read more

broken ignitor insulation; repeated sparking after burner lit

  • Customer: Joe from San Bruno CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench(Adjustable)
  • 8 of 13 people found this instruction helpful
Disconnected gas & electric connections; lifted unit out of countertop onto padded table upside down. Unscrewed ~16 sheet metal screws for access. Removed bad ignitor by driving off retaining clip. Had to remove burner (3 screws) for access to install retaining clip on new ignitor. Reassembled, reinstalled. Works like new! read more