ADW1100N10WW General Electric Dishwasher - Instructions

Check website, order part. Hardest part was determining which was the right part. Needed the axle--I call it the hanger. I had previously called and ordered, but only received the wheel with no way to attach it. Push the axle into the wheel. Push the axle onto the rack. Since it was new, it didn't slip right on, and had to push it hard. (However, when it snapped on, three of the other wheels and axles came off.) Had to put them back on as well. Much easier, as they were older and not as snug. Total time: Took longer to open the package than put it on.

I disconnected the pipes to the inlet valve. I removed the bolts from the bracket holding the valve. I tried to use two wrenches to remove the brass angle pipe thingie off the bottom of the old valve. I then beat on it with a hammer, then I just threw it against the basement floor till it came off. I would recommend getting a new brass angle pipe thingie before you start.

My son took the part and it plop right into place with a click, and we were able to use are dishwasher again,Thanks

Wow... Simple... Just pulled the old broken axle off, pushed the new wheel onto the axle then snapped onto the wire basket. Ez and cheap repair but it keeps an off balance dragging sliding from causing more damage.

Merely pushed the baffle into the slots in the lower right corner and the leak stopped.

By GE dishwasher badly leaked under load. I was about to shop for new dishwasher ($400 ?) when I had found your website. With likely reason identified, inexpensive parts readily available and video instructions being very clear, I had decided to try to fix my dishwasher myself. Parts arrived on schedule and I had replaced my old corner baffles in 1 minute with no tools at all. It fixed the problem with my dishwasher with minimal trouble for me for less than $30. Thank you.

just lifted out the old one & replaced it with the new one. Couldn't have been easier.

Ordered the part from you and it was easy to replace.

In replacing the upper rack in our dishwasher, I struggled and broke one of the end caps (see previous tale of woe. With the new end caps, I finished the job in less than two minutes with no tools. BUY END CAPS when you order a rack!

replaced the rubber baffle

I removed the broken stub of the old fill cap with a screw remover. This was the only part that wasn't easy. The new cap fit fine.

Took the back off/there were six phillips head screws. Took the protective cover off the Interlock Switches and found the problem. One of the buttons was jambed and would not move. I pulled the switch up and pulled the connecting wires. This took a little bit of doing as the connectors have been set for over 8 years. I used a pair of needle nose pliers. I reconnected the new switch and punched both switches and the washer started. It was an easy repair after that, putting everything back in reverse order.

Removed bottom panel unplugged wires removed two screws removed it then replaced it

Had to install a new door latch. The installation itself is really quite simple involving removing (separating) the inner door panel to access the latch assembly. The latch is removed by simple push through one slot with a screw driver and the new unit basically pops in through grooved slots. However, I did find it quite helpful to first (and during) review a YouTube video illustrating the replacement. Although it is largely a simple procedure, for the first-time "installer" there are still a few tricky nuances to be aware of.

First I turned off the breaker to the dishwasher. I then removed the bolts that held on the inner cover(note the two small bolts go on the bottom one on each side). I lifted the switch up and disconnected the wire clips from each side. I then put the new switch in place with the wires attached. Then replaced the cover and screwed it into place. Closed the door and flipped the breaker back on and turned the dish washer on and it started up. A very easy replaceable part.