A100 - Instructions

Just tilt the washing machine, take out the old and put back the the one its so easy. You don't have take out anything.

I followed the video provided. The video was very clear and helpful.

took out the screws replaced the cartridge top, replaced the screws

followed video from your website. Nut does not come off as easy as your video shows.

dissembled the burner, remove the broken blocpk and bad spade.rewiered and assembled the burner.

burner replaced

The repair itself is really quite easy. Cut the wires, strip the ends and attach the new receptacle with wire nuts. The hard part was getting to it. My cooktop is about 30 years old, so I had to wade through piles of nasty built up grease. Some of the sheet metal screws were unworkable, so I had to cut them off with a Dremel tool. Not a pretty picture, but that's how repair work is on old stuff.

The video on your website showed me how to take out 1 screw, cut the existing wires and strip the ends. The kit came with 2 porcelan wire nuts to re-connect the wires and it was done. Less than 10 minutes. It saved me $100.00 to get it repaired.I bought 2 in case I need another one in the future.They only cost $11.00 each. Awesome website.

took old screw out of stove top that held them in and cut the two wires off close to the burner stripped the wires and used the screw caps to put each line together it doesn't matter which line goes where and screwed it back on with the old screw and tried the two burners and they both worked job done ps it took longer for me to type this but i am slow at typing

watched video, ordered parts, parts arrived fast in two days, watched video again, Repaired washer saved money

Remove front panel removed two screws holding top down, then removed plastic tube cover, removed balancer to make more room to work. Next removed set screw holding dasher, next remove spanner nut that held inner tube shield. Tthen lifted inner tube out of washer, now I removed the stem hold down and seal important clean area where seal touches the tube nowuse little water to wet new seal pt new seal ln careful not to damage simply reverse removal step and put the unit back together

contacted Justanswer.com with description. Expert defined problem, identified part need and gave us link to your website. Rapid arrival of part, but we took a couple of weeks to get around to it as the washer was operational, just noisy. Website video of how to do repair was invaluable. Watched prior to starting the job and checked video again during repair to verify understanding. Wonderful to be independent of the vagaries of appliance repair. I would recommend Justanswer and PartSelect to anyone!

Exactly as shown in your provided video from You Tube. What a life saver. The description of needed tools, and the fact that the main nuts securing the tub were REVERSE thread! I would not have suspected that and probably would still be beating on them, tightening them rather than loosening them!It is worth the price to purchase the spanner wrench (correct style), used to remove those tub nuts. Thanks for the great service and the video. Well done!

The repair went well.I had to replace the seal under the tub.The video was the key to my success,I did not have a spanner wrench,I don't think it would have helped anyway,The nut was corroded I had to drill holes and chisel it apart after that it was no problem.

I did an internet search for a leaking washer and came across this web site.I looked under my washer model and it showed the repair parts plus it has a video of a repairman doing the job.The video was none the less the best help I could ever imagine.Tools needed and how to do the job a step at a time.The parts came to my door in two days via regular shipping method.I also purchased the special SPANNER WRENCH on eBay for about 10 bucks and it showed up the same day as my parts.The job took me about a hour and now my washer works like it should with no leaks.Thanks to Parts Select I highly recommend this site and their my new lifesaver. Ciao, Steve M