Models > 95 1987 23 02

95-1987-23-02 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for 95-1987-23-02

If you know the refrigerator repair part you need, you can browse the list of all parts on the 95-1987-23-02, or you can search by name or part description. You can also find your part by where it is located on the 95-1987-23-02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for 95-1987-23-02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the 95-1987-23-02 [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$28.51

Evaporator Fan Motor Kit

This motor runs the evaporator fan in your refrigerator. It is mounted on the center hub and has three lead wires terminals. This motor rotates in a clockwise fashion. Its shaft ha...

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$23.91

Evaporator Fan Blade

$16.76

TIMER-DEFROST

$5.20

Hexagonal Screw

$7.36

SWITCH-LIGHT/LAMP

$2.48

Ice Cube Tray

Sold individually.

$80.98

Door Gasket

This almond door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$25.05

Crisper Drawer Cover Support Bar

$9.06

DRIER-FILTER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Noisy fan

  • Customer: Jordan from Maumee OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 38 of 45 people found this instruction helpful
1. Removed the 7 nuts using the nut driver from the freezer back panel inside the freezer.
2. Remove the back panel. The evaporator motor and fan are located above the coils.
3. Unplug the wiring harness.
4. Remove the two gold mounting screws holding the motor and fan in place.
5. Remove the motor and fan including the brackets.
6. ... read more

THE EVAPORATOR FAN BURNT UP

  • Customer: ROY from PENSACOLA FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 16 of 22 people found this instruction helpful
THE FAN MOTOR ALL BUT CAUGHT THE INSIDE OF THE FREEZER ON FIRE . HAD TO REMOVE THEN CLEAN, AND I MEAN CLEAN THE WALLS OF THE FREEZER . THEN HAD TO PRY OUT THE OLD FAN WITHOUT BREAKING ANYTHING . REPLACEMENT OF NEW FAN WAS QUICK AND EASY BECAUSE ALL THE PARTS THAT I NEEDED WERE IN THE BAG read more

door seals cracking from age on both compartments

  • Customer: Clark from Wenatchee WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 12 of 14 people found this instruction helpful
Located the many screws which hold the inside surface of the door on. The screws are located between the seal and the inside surface; you have to hold back the seal to find the screws.

The seals are attached to this inner surface by a snug fit, and clamped in place when the screws are tightened again. Its simpler than it sounds.

Final... read more